PAN AS-OIL 1018564 - Caterpillar

Specifications
Table 1
Parameter Value
Fuel Manifold Pressure 415 to 450 kPa (60 to 65 psi)
Fuel Transfer Pump Pressure 415 to 450 kPa (60 to 65 psi) Introduction
Use this procedure to check the regulated fuel pressure. Required Tools
Table 2
Required Tools
Qty Part Number
1 1U-5470 Engine Pressure Gp
Illustration 1 g01192577
1U-5470 Engine Pressure Group
(1) Pressure indicators
(2) Zero adjustment screw
(3) Pressure indicator
(4) Pressure tap
(5) Pressure indicator This tool group has an indicator that is used to read the pressure in the fuel manifolds. The Special Instruction, SEHS8907 is with the tool group.Test Preparation - Fuel Manifold Pressure
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately.
Illustration 2 g00284797
Fuel manifold and lines
(6) Fuel supply line to cylinder head
(7) Fuel manifold
Turn off the engine
Install a tee fitting into fuel line (6). Connect the 1U-5470 Engine Pressure Gp to the tee fitting. Refer to Illustration 2 Test Preparation - Fuel Transfer Pump Pressure
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately.
Illustration 3 g00284797
Fuel manifold and lines
(6) Fuel supply line to cylinder head
(7) Fuel manifold
Turn off the engine
Install a tee fitting into fuel line (6). Connect the 1U-5470 Engine Pressure Gp to the tee fitting. Refer to Illustration 2 Test Procedure - Transfer Pump and Fuel Manifold Pressure
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately.
Turn off the engine.
Illustration 4 g01290055
Fuel transfer fuel lines and fuel filter fuel lines.
(8) Fuel inlet line to priming pump
(9) Plug
(10) Line from fuel filters to fuel manifolds (filtered fuel)
(11) Fuel priming pump adapter
(12) Fuel line from transfer pump
(13) Fuel filters
Slowly loosen plug (9). Refer to Illustration 4.
Connect the 1U-5470 Engine Pressure Gp into the pressure tap (9).
Start the engine
Operate the engine at rated speed and load.
Note the pressure readings. If,