PAN GP-TRANSMISSION OIL 2664196 - Caterpillar

Personal injury could result from the sudden movement of the blade when the centershift lockpin is released.Before releasing the centershift lockpin be sure that all personnel are clear of the blade area, the circle and blade are centered under the machine and the blade has been lowered to the ground.
Use the centershift control lever in order to shift the drawbar. Move the drawbar toward the area that will be graded. Place both lift levers in FLOAT position in order to ground the moldboard.
Move the switch for the centershift lock to the DISENGAGED position. When the switch for the centershift lock is in the DISENGAGED position, an indicator light will illuminate on the front dash.
If you want to move the link bar to the first hole to either side of center or the second hole to either side of center, proceed to Step 3.a. If you want to move the link bar to the third hole to either side of center or to the farthest hole to either side of center, proceed to Step 3.c.
Make sure that the blade lift levers are still in the FLOAT position. Move the centershift control lever in the opposite direction that moved the lever in order to position the drawbar in Step 1. The centershift cylinder moves. This allows the linkage to roll freely. Also, the link bar will move sideways.
Continue with Step 4.
Move the blade lift levers out of FLOAT position.
Simultaneously, move the centershift control lever forward and move the right blade lift lever forward. At the same time, pull back on the left blade lift lever.
Line up the centershift lock pin with the desired hole in the link bar. Use the indicator that is on the right lift arm to check the alignment.
Move the switch for the centershift lock to the ENGAGED position. The indicator light for the centershift lock will turn off when the centershift lock pin is engaged.Note: If the indicator light for the centershift lock does not turn off, slightly move the link bar for the centershift in order to align the hole with the centershift lock pin.
Sideshift the link bar toward the area that will be cut. Use the blade lift cylinders in order to adjust the angle of the slope that will be cut.