PAN AS-OIL 2831287 - Caterpillar

2831287 PAN AS-OIL Caterpillar parts 303.5C, 303.5D, 303C CR, 304D CR

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2831287
283-1287
2831287

Weight: 6 pounds 2 kg.

Buy PAN AS-OIL 2831287 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

2831287 Pack of 4 VALVE STEM SEAL Suitable For Iveco 2831287

$17.74

20 Jul 2025

US: KMP BRAND

2831287 Pack of 4 VALVE STEM SEAL Suitable For Iveco 2831287
KMP BRAND Suitable for Iveco

$17.74

12 Jun 2025

US: KMP BRAND

2831287 Pack of 4 VALVE STEM SEAL Suitable For Iveco® 2831287
KMP BRAND Suitable for Iveco

$28.46

14 May 2025

US: KMP BRAND

2831287 Pack of 4 VALVE STEM SEAL Suitable For Iveco® 2831287
KMP BRAND Suitable for Iveco

This part in 1 request: Show. This information for suppliers only!

#778292 2831287

2021-12-22

Number on catalog scheme: 5

Caterpillar 2831287 Parts scheme PAN AS-OIL

For full view, you need register

Compatible equipment models: 2831287:

MINI HYD EXCAVATOR 303.5C 303.5D 303C CR 304D CR Caterpillar

Information:

Illustration 1 g02042457
Schematic of the "Auxiliary Pedal 1 Control Pressure" SensorThis diagnostic code is associated with the "Auxiliary Pedal 1 Control Pressure" Sensor. This diagnostic code is recorded when the Machine ECM reads the frequency of the signal and the frequency is not within an expected range. Note: Before performing the following procedure, ensure that the diagnostic code for this procedure is active.The possible causes of this diagnostic code are listed below:
The sensor has failed.
Intermittent connections or poor connections
The Machine ECM has failed. A failure of the ECM is unlikely.Test Step 1. CHECK THE +8 VDC SUPPLY VOLTAGE.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the sensor.
Turn the disconnect switch and the key start switch to the ON position.
At the machine harness connector for the sensor, measure the voltage (VDC) between contact 1 (wire J850-WH) and contact 2 (wire 235-BK).
At the machine harness connector for the sensor, measure the voltage (VDC) between contact 1 (wire J850-WH) and frame ground. Expected Result:The voltage is 8 0.5 VDC for both measurements. Results:
OK - The voltage is 8 0.5 VDC for both measurements. The voltage is correct. Proceed to Test Step 2.
NOT OK - The voltage is NOT 8 0.5 VDC for both measurements. The voltage is not correct. The Machine ECM has failed or the harness has failed. Repair: A failure of the ECM is unlikely. Verify the harness. If the harness is correct, replace the Machine ECM. STOPTest Step 2. VERIFY THE GROUND OF THE SENSOR.
At the machine harness connector of the sensor, place a jumper between contact 2 (wire 235-BK) and frame ground.
At the machine harness