PAN AS-OIL 3548538 - Caterpillar

Illustration 1 g06270649
Table 1
Item Qty Part Description
1 2 2D-8426 Taperlock Stud Torque to 65 10 N m (48 7 lb ft).
2 1 5D-9514 Bolt Torque to 270 25 N m (200 18 lb ft).
3 1 1D-4574 Bolt Torque to 135 15 N m (100 11 lb ft).
4 2 3D-8439 Stud Torque to 110 15 N m (80 11 lb ft).
5 12 5P-2546 Bolt Torque to 90 15 N m (60 11 lb ft).
6 1 7N-3005 Idler Shaft Bore in bearing after assembly 94.000 0.005 mm (3.7008 .0002 inch).
Diameter of new shaft 93.870 0.012 mm (3.6957 .0005 inch).
7 2 7N-3006 Thrust Washer Assemble the washer by placing on dowels in flywheel housing with the tighter fit dowel hole on the upper dowel.
8 1 8N-8041 Shaft As Bore in bearings after assembly 63.500 0.038 mm (2.5000 .0015 inch).
Diameter of new shaft 63.420 0.013 mm (2.4968 .0005 inch).
9 2 5D-3954 Taperlock Stud Apply 4C-9502 Gasket Sealant to the threads of the studs.
Torque to 100 15 N m (74 11 lb ft).
10 2 4K-0367 Full Nut Torque to 220 25 N m (162 18 lb ft).
Illustration 2 g06270653
View of area B
Table 2
Item Qty Part Description
11 1 8N-8039 Adapter As Install the bearing below the surface of the adapter assembly 1 .5 mm (0.0394 0.0197 inch).
Illustration 3 g06270656
View of area C
Table 3
Item Qty Part Description
12 1 163-2600 Cage As Align the holes in the bearing with the holes in the cage assembly.
Install the bearing below the surface of the cage assembly 1 .5 mm (0.0394 0.0197 inch).
Illustration 4 g06270657
View of area D
Table 4
Item Qty Part Description
13 1 7N-2909 Cluster Gear Assembly Install the bearing below the surface of the gear 1 .5 mm (0.0394 0.0197 inch).