PAN AS-OIL 3838332 - Caterpillar

Removal Procedure
Start By:
Remove the engine.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the engine oil into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct draining and filling procedures.
Illustration 1 g01153839
Note: Do not pry or gouge the sealing surface of the engine oil pan. Use a rubber mallet to tap lightly on the engine oil pan, if necessary.
Remove bolts (2) . Remove engine oil pan (1) and the gasket.Installation Procedure
Table 1
Tool     Part number     Part Description     Qty    
A     -     Loctite 598     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g03737518
Apply a bead of Tooling (A) to the areas shown in Illustration 2.
Illustration 3 g03738044
Position a new gasket and engine oil pan (1) on the cylinder block.
Install bolts (2) .
Tighten bolts (2) to a torque of 31 3 N m (23 2 lb ft). Tighten the four bolts (2) in the center and move outward in the direction shown in Illustration 3.
Repeat Step 4.
Fill the engine with engine oil to the correct level. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct draining and filling procedures.End By: Install the engine.