PAN GP-OIL 4N0771 - Caterpillar

VALIGN=TOP WIDTH="37%">Part Number Description
2 2N0931 GASKET
4 3S9643 SEAL-LIP TYPE
2 6V1454 SEAL-O-RING
4 8L8585 SEAL
2 1107753 SEAL-O RING
1 3271115 PLATE AS
4 4410371 REGULATOR-TEMP
1 4493063 PLATE AS-CHANNEL
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 32% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-10000 hrs,
0-48 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 5.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Replace the thermostats located in the housing behind the expansion tank with the new 441-0371 thermostats.
Remove the heat exchanger from the engine.
Disassembly Procedure
Refer to Disassembly and Assembly, KENR6055, to disassemble the heat exchanger.
Remove 48 plates (along with gaskets) starting from the SCAC side until reaching plate number 15.
Image1.3.1
Assembly Procedure
Take the plate numbers 44, 45, 46 and 47 (along with the gaskets) from the SCAC side and place them between plate numbers 15 and 16 while maintaining the same order (44, 45, 46 and 47).
Make sure the chevrons are facing opposite to each other.
Image1.5.1
Replace plate #62 with the new 449-3063 Plate As-Channel.
Inspect plate #63 for corrosion damage and replace if needed.
Refer to Disassembly and Assembly, KENR6055, to reassemble the heat exchanger.