PAN-OIL 7W7729 - Caterpillar

Illustration 1 g06221609
Right side view of machine
Table 1
Item Qty Part Specification Description
- - - Fill port on the cartridge assembly must be between the 10 o'clock and the 2 o'clock positions with the bucket flat on the ground. Ensure that the fill port does not intersect with the retainer.
Illustration 2 g06221610
Section A-A
Table 2
Item Qty Part Specification Description
2 4 9X-7699 Lip Type Seal During assembly, ensure to properly orient seal.
Before assembly of pin, lightly lubricate seal lip with black 5P-0960 Moly Grease Cartridge.
Add 5P-0960 Moly Grease Cartridgethrough bucket links until grease extrudes through seals.
3 2 4E-5597 Pin As Before assembly of pin, lubricate pin diameter and bearing inner diameter with GL-5 gear oil.
Diameter is 142.00 0.25 mm (5.591 0.010 inch).
Illustration 3 g06221613
Section B-B
Table 3
Item Qty Part Specification Description
4 2 272-6133 Duo-Cone Seal Gp The rubber toric seals and all the contacting surfaces must be clean and dry at assembly. Before assembly, apply a thin film of oil to the contacting surfaces of the metal seal rings. The metal seal rings must be assembled square. Ensure that the rubber toric seal should not bulge and the rubber toric seal should not twist.
5 As required, use the following shims to reduce gap to less than 1.0 mm (0.04 inch):
10 241-4960 Shim Thickness is 1.22 0.18 mm (0.048 0.007 inch).
6 32 118-7313 Bolt Before assembly, apply red Loctite 263 to the threads.(1)
7 8 266-6039 Dowel Pin Before assembly, rotate boom to align dowel holes.
8 2 311-1898 Cartridge As The fill port on the cartridge assembly must be between the 10 o' clock and 2 o' clock with the bucket flat on the ground.
Ensure that the fill port does not intersect with the retainer.
Before assembly, apply Loctite C5A Copper Anti-seize to all bores.
9 2 251-9661 Bushing Bore before assembly is 128.150 0.025 mm (5.0453 0.0010 inch).
10 As required, use shims to achieve clearance (C) of 0.5 to 1.0 mm (0.02 to 0.04 inch) at the closest point between the outside face of the insert and back side face of the end plate:
12 251-9680 Plate Thickness is 2.5 mm (0.10 inch).
4 251-9678 Plate Thickness is 1.0 mm (0.04 inch).
(1) Before applying sealant, clean all the bolts.