PAN ASSEM. 8S8204 - Caterpillar

Table 1
Tools Needed    
Part Number     Part Name     Quantity    
348-5430     Multi-Tool Gp     1    
285-0900     Blowby Tool Group     1    
NETG5044     Software license     1    Note: For a new G3306 Engine that is operating at 1800 rpm, the typical crankcase blowby is approximately 60 to 120 LPM (2 to 4 CFM).Measure the crankcase blowby of an engine after approximately 250 hours of operation. Record the data as a benchmark. Continue to measure the blowby periodically. Comparing the recorded data to the new data provides information about the condition of the engine.Note: Crankcase blowby is one of the three factors that help to determine the major overhaul interval. Refer to Operation and Maintenance Manual for the maintenance intervals for this engine.After a new engine is operated for a short time, the blowby can decrease as the piston rings are seated. The blowby will gradually increase as the piston rings and cylinder liners show wear. More fumes are exhausted through the crankcase breather. The crankcase breather will become clogged more rapidly. Excessive crankcase pressure can also cause engine oil to leak at the gaskets and the seals.The blowby of a worn engine may exceed the blowby of a new engine by two times or more.Note: A problem with the piston rings causes the engine oil to deteriorate rapidly. Information regarding the condition of the piston rings can be obtained from the blowby measurements and the engine oil analysis.A sudden increase in blowby could indicate a broken piston ring. This condition will cause the engine to run rough. The following conditions are other potential sources of blowby:
Worn valve guides
A turbocharger seal that leaksA rebuilt engine can have a high blowby due to the following factors:
The piston rings are not seated properly.
Worn parts such as valve guides were not replaced.By keeping a record of the results, a gradual increase in the amount of the blowby will be noted until the amount has become excessive.The 348-5430 Multi-Tool Gp with the 285-0900 Blowby Tool Gp is used to check the amount of blowby.Keep a record of the results of the test.