PAN-MOUNT 8Y6368 - Caterpillar

Personal injury may occur when removing and installing windows in the operator station.The windows may break during removal or installation.Broken or cracked windows may have sharp edges that can cause cuts or lacerations.To avoid injury always ensure adequate personal protective equipment (protective glasses, face shield and gloves) are worn.
Incorrect window sealing (beading) may obstruct window removal and may cause inability to use alternate exit. Personal injury can result. Use the correct method of sealing (beading) to secure the operator's station windows. Contact your Caterpillar dealer for the correct sealing (beading) method.
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     4C-9946     Tool     1    
5H-4845 Seal Installer Gp     1    
B     5N-5561     Silicone Lubricant     1    
Illustration 1 g03850199
View of side alternate exit
Illustration 2 g03850200
View of rear alternate exit
Disconnect the wiper washer hose and remove the wiper blade assembly.
Pull on locking strip tag (1) to remove the locking strip.Note: Use two people to remove the window.
From inside the operator station, exert steady outwards pressure on a corner of the window until the window separates from the operator station frame.
Remove the window and the seal strip.
Inspect each alternate exit for the following conditions.
Window frame rust
Missing components
Damaged or rusty locking strip tab
Damage, cracking, or hardening of the seal strip and locking strip
Replace any damaged, cracked, hardened, or missing components. Repair and repaint any rusted window frames.
Apply Tooling (B) between the cab window frame and the seal strip. Apply Tooling (B) between the window glass and the seal strip.
Install the seal strip, and the window.
Install the locking strip and locking strip tag (1). Position locking strip tag (1) as shown in illustration 1 and illustration 2.Note: Ensure locking strip tag (1) is installed on the opposite side of the window to the join in the locking strip.
Install the wiper blade assembly and connect the wiper washer hose.
Repeat Step 1 through Step 10 for the other alternate exit.