PANEL A 0927092 - Caterpillar

Illustration 1 g02563536Note: All bores must be free of paint. Use the 5P-0960 Grease Cartridge in order to coat all bores for the pins, the stick, the upper frame, and the cylinder pin bores.
Table 1
Specification for 339-4088 Boom, and 341-5113 Boom
Item Qty Part Specification Description
1 2 166-1496 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install the lip type seals so that the lip type seals do not extend beyond the face of the boss.
2 2 228-5617 Bushing Install the bushing in the bore so that the part number of the bushing is facing outward.
Inside diameter before assembly is 100.29 0.04 mm (3.948 0.002 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).
3 1 4I-4809 Pin As Diameter is 79.850 0.025 mm (3.1437 0.0010 inch).
4 1 180-7752 Pin Diameter is 89.850 0.025 mm (3.5374 0.0010 inch).
5 1 343-9246 Pin As Diameter is 99.85 0.04 mm (3.931 0.002 inch).
6 As required, use the following shims to adjust the following maximum lateral clearance. The steel shim should be located at the boom side:
Lateral clearance for Gosselies facility 1.0 mm (0.04 inch).
Lateral clearance except for Gosselies facility 1.6 mm (0.06 inch).
1 133-2427 Shim Thickness is 0.5 mm (0.02 inch).
1 093-0090 Shim Thickness is 1.0 mm (0.04 inch).