PANEL GP-RELAY 1415418 - Caterpillar

Illustration 6 g00497954
Remove bearing cup (8) from the transfer gear case.
Illustration 7 g00497996
Typical Example
Use a hoist to place the transfer gear case in a vertical position, as shown. The weight of the transfer gear case is 193 kg (425 lb).
Remove nuts (9) and the washers. Use two 3/8" - 16 NC forcing screws to loosen bearing cage (10). Remove bearing cage (10) .
Illustration 8 g00498021
Typical Example
Remove O-ring seal (13), lip type seal (11) and outer bearing race (12) from bearing cage (10) .
Illustration 9 g00498024
Typical Example
Remove spacer (14) from the output shaft.
Illustration 10 g00498025
Remove the bolt, the retainer, the O-ring seal and the yoke from the output shaft. Remove the dirt guard from the output shaft.
Remove bearing retainer (15) .
Illustration 11 g00498026
Remove lip type seal (16) from bearing retainer (15) .
Illustration 12 g00498028
Install two 3/8" - 16 NC guide bolts through the bearing cage (17), as shown.
Illustration 13 g00498030
Fasten a lifting strap and a hoist to transfer gear (18), as shown. Use a soft faced hammer to push shaft (20) out of transfer gear (18) and the bearing cage. Remove bearing (19). Remove output shaft (20) and bearing cage (17) from the opposite side of the transfer gear case.
Illustration 14 g00498240
Remove O-ring seal (21) from bearing cage (17) .
Illustration 15 g00498260
Use a press to push output shaft (20) out of bearing cage (17) .
Illustration 16 g00498284
Use Tooling (B) and a press to push the bearings out of bearing cage (17) .
Illustration 17 g00498285
Remove transfer gear (18) from the transfer gear case.
Illustration 18 g00498286
Remove covers (23) and the gaskets from both sides of the transfer gear case.
Remove cover (22) and the gasket from the transfer gear case.
Illustration 19 g00498287
Remove screen tube assembly (25) and screen (24) .