PANEL GP-INSTRUMENT 1609170 - Caterpillar

27. Install the No. 4 planetary carrier (45) in clutch housing (55). 28. Turn clutch housing (55) and the No. 4 planetary carrier over and install the plate and bolt (61) to hold the carrier in position. Make sure the boss in the plate is engaged with the hole in the No. 4 planetary carrier. Tighten bolt (61) to a torque of 34 2 lb.ft. (45 3 N m).29. Install ring (60) in No. 3 carrier (47). 30. Install tooling (A) to hold the No. 4 piston in position in clutch housing (55).31. Install two 1/2"-13 NC forged eyebolts in clutch housing (55) and fasten a hoist to it.32. Put clutch housing (55) in position on the transmission. Make sure the springs are correctly engaged in the No. 4 piston.33. Remove the eyebolts and tooling (A). 34. Make sure No. 3 piston (63) is in position in clutch housing (55) and install ring gear (62). 35. Install pins (65), the four disc assemblies (64) and three plates (66). Start with a disc assembly. 36. Put ring (60) under compression to install gear (67). 37. Use a hammer and punch and install pins (68) to hold the ends of the ring apart inside gear (67). 38. Install springs (71).39. If necessary, make a replacement of dowels (70) in No. 2 clutch housing (69) so they extend to the same height as the original dowels.40. Install No. 2 clutch housing (69) and piston. Make sure springs (71) engage in the holes in the No. 2 clutch housing. 41. Install ring gear (74), the five disc assemblies (72) and four plates (73). Start with a disc assembly. 42. Install pin (78), seal rings (77) and coupling (75) in shaft assembly (76). Install the ring that holds coupling (75) in shaft assembly (76).43. Install the seal ring on coupling (75).44. Install shaft assembly (76). 45. Assemble No. 2 planetary carrier as follows: a) Install the seal ring on carrier assembly (79).b) Install bearings (80) and (82) in each gear (81).c) Put gears (81) in position in carrier assembly (79) with washers (85) on each side of the gears.d) Install shaft (83) in carrier assembly (79) to hold gears (81) and washers (85) in position. Make sure the holes in the shafts are in alignment with the holes in the carrier assembly.e) Install pins (84) even with the surface of carrier assembly (79) to hold shafts (83) in position. 46. Lower the temperature of bearing (87) and install it in plate (89). Make sure the notch in bearing (87) is down when it is installed in the plate. Install ring (86) to hold the bearing.47. Heat sleeve (88) in oil to a maximum temperature of 275°F (135°C) and install it on carrier