PANEL GP-INSTRUMENT 2006839 - Caterpillar

Remove truss head screws (5) and plate (6). Remove horn button (7) and console cover (8). Disconnect the wiring harness (not shown) that is connected to the lighter.
Illustration 3 g00590557
Remove truss head screws (9) and console cover (10) .
Illustration 4 g00590562
Disconnect hoses (11) for the windshield washers. Disconnect electrical connector (12) .
Illustration 5 g00590564
Remove the cover behind the instrument panel. Remove bolts (13) with the washers.
Illustration 6 g00590566
Attach Tooling (A) and a hoist to cab (14) .
Illustration 7 g00590568
Remove mounting bolts (15). Remove the cab from the machine. The cab weighs approximately 550 kg (1200 lb).Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7575     Link Bracket     1    Reference: Refer to Specifications, "Cab Mounting" in the Service Manual for your machine.Reference: Refer to Specifications, "Rollover Protective Structure (ROPS)" in the Service Manual for your machine.
Illustration 8 g00590566
Attach Tooling (A) and a suitable lifting device to cab (14) .
Illustration 9 g00590568
Note:
Position the cab on the machine. The cab weighs approximately 550 kg (1200 lb). Install mounting bolts (15) on the machine.
Remove the hoist from cab (14). Remove Tooling (A) .
Illustration 10 g00590564
Install the cover behind the instrument panel. Install bolts (13) with the washers.
Illustration 11 g00590562
Connect electrical connector (12). Connect hoses (11) for the windshield washers.
Illustration 12 g00590557
Install console cover (10) and truss head screws (9) .
Illustration 13 g00587826
Connect the wiring harness (not shown) that is connected to the lighter. Install console cover (8) and horn button (7). Install plate (6) and truss head screws (5) .
Illustration 14 g00587826
Install armrest (3). Install bolts (4) with the washers. Install boot (2) and handle (1) to the control lever.End By: Install the rollover protective structure (ROPS). See the procedure in Disassembly and Assembly, "Rollover Protective Structure (ROPS) - Remove and Install" in this module.