PANEL GP-ENCLOSURE 2040616 - Caterpillar

Table 1
Required Tools     A     B    
(1)     1P-3703 O-Ring Seals     2        
(1)     1P-3704 O-Ring Seals         2    
(2)     9U-5934 Hydraulic Test Adapter     2        
(2)     9U-5936 Hydraulic Test Adapter         2    
(3)     7M-8485 O-Ring Seals     4     4    
(4)     9S-9334 Plugs     2     2    
(5)     9U-7446 Flange Adapters     2     2    
(6)     1P-4579 Flanges     4     4    
(7)     8T-8919 Bolts     8     8    
(8)     8T-4223 Hard Washers     8     8    
(9)     4J-0524 O-Ring Seals     2     2    
(10)     4C-9675 Hydraulic Flow Tester     1     1    
Illustration 1 g00486529
Install the rotational safety lock (11) on the Crusher.
Illustration 2 g00536318
Illustration 3 g00485391
Install tooling (A) to fittings (12) and (13) (S/N: 4DW, 4JW). Install tooling (B) to fittings (2) and (3) (S/N: 5BW, 5ZW).
Start the machine. Run the machine at high idle until the hydraulic oil reaches normal operating temperature.
Move the attachment control lever to the OPEN position. Record the flow meter reading.
Move the attachment control lever to the CLOSED position. Record the flow meter reading.The maximum recommended cylinder flow for each model is listed below. CR20 ... 160 L/min (42 US gpm) CR28 ... 180 L/min (48 US gpm) CR35 ... 250 L/min (66 US gpm) CR50 ... 450 L/min (119 US gpm)
Refer to the Testing and Adjusting procedures of the machine if the oil flow is incorrect.