PANEL AS-ELECTRICAL 2451678 - Caterpillar

Illustration 13 g00763613
Remove gears (19). Remove gear (20) .
Illustration 14 g00763623
Remove shaft (21). Remove bearing (22) .
Illustration 15 g00763684
Remove pivots (23), and lip seal (24) .
Illustration 16 g00764056
The thread lock compound that is used on the reamer bolts may cause the reamer bolts to seize during removal.The reamer bolts should be slowly removed by hand. Do not use an impact wrench in order to remove the reamer bolts. If the reamer bolts will no longer turn during removal, do not force or complete the removal. Instead, tighten the bolts, then try to loosen them again.
Carefully remove bolts (25). Remove retaining rings (26) .
Illustration 17 g00763700
Use Tooling (B) in order to separate spindle (27) from housing (28) .
Illustration 18 g00764796
Remove flange (29), and bearing (30) .
Illustration 19 g00764176
Remove gear (31) .
Illustration 20 g00764194
Remove shaft assemblies (32), and gear (33) .
Illustration 21 g00764198
Remove bearing cone (35), and bearing cone (38) from shaft (34). Remove bearing (36), and bearing (37) from shaft (34) .
Illustration 22 g00862751
Remove Duo-Cone seal kit (39). Remove pins (40). Remove bearing (41) .
Illustration 23 g00764855
If necessary, remove valve (42). Remove bearing (43) .
Illustration 24 g00764867
Remove plugs (44), and the O-ring seals. Remove springs (45), stoppers (46), and spool (47) .
Illustration 25 g00764880
Remove plugs (48), and the O-ring seals. Remove springs (49), and stoppers (50) .
Illustration 26 g00764899
If necessary, remove plugs (51). Remove plug (52), and the O-ring seal. Remove plug (53) .