PANEL AS 2658947 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00580373
Remove four screws (1) that secure bezel (2) and message center (3) to the dash. Remove bezel (2) from the dash.
Illustration 2 g00580375
Pull message center (3) away from the dash.
Illustration 3 g00580377
Disconnect wire harness (4) from the message center (3) at the electrical connection. Disconnect two lamps (5) from message center (3).
Remove message center (3) from the dash.Installation Procedure
Verify that all of the components of the message center module are clean and free of foreign material prior to installation.
Inspect all of the components for wear and replace the components, if necessary.
Illustration 4 g00580377
Position message center (3) to the cab.
Connect two lamps (5) to message center (3). Connect wire harness (4) to the message center (3) at the electrical connection.
Illustration 5 g00580375
Position message center (3) to the dash.
Illustration 6 g00580373
Position bezel (2) to the dash. Install four screws (1) that secure bezel (2) and message center (3) to the dash.