PANEL GP-ELECTRICAL 2668870 - Caterpillar

Changing Machine Control Pattern
If the machine is equipped with the 2-way valve, the machine control pattern can easily be changed to either the SAE system or the BHL (Standard Backhoe Loader) system by changing the 2-way valve position. To change the 2-way valve position, use the following procedure.The 2-way valve, if equipped, is located at the left front of the swing drive. Loosen bolt (1) and place lever (2) in the correct position. To select the BHL system, turn lever (2) fully clockwise. To select the SAE system, turn lever (2) fully counterclockwise. After turning lever (2) to the desired position, tighten bolt (1) securely.Hydraulically Activated Hydraulic Hammer Controls (Type A) (If Equipped)
Hammer Enable Switch
The hammer enable switch is located on the right console. Hammer Enable - Press the front of the switch to turn the hammer circuit on.Hammer ON/OFF Control
The right auxiliary foot pedal acts as the hammer ON/OFF switch. Hammer ON - Push down on the pedal to activate the hammer. Hammer OFF - Release the pedal to deactivate the hammer.Hammer Speed Control
The hammer speed switch is located on the left implement control lever. High - Push down on the top right button for the high hammer stroke frequency. The hammer will stay in high until the button is released. This position is the high speed low impact energy mode. Low - Release the top right button for the low hammer stroke frequency. This position is the low speed high impact energy mode.Electrically Activated Hydraulic Hammer Controls (Type B) (If Equipped)
Hammer Enable Switch
The hammer enable switch is located on the right console. Hammer Enable - Press the front of the switch to enable the hammer.Hammer ON/OFF Control
The hammer ON/OFF switch is located on the right implement control/lever. Hammer ON - Push down the top left button on the right implement control lever to activate the hammer. Hammer OFF - Release the top left button on the right implement control lever to deactivate the hammer.Hammer Speed Control
The hammer speed switch is located on the left implement control lever.The hammer stroke frequency switch is located on the left implement control lever. High - Push down on the top right button for the high hammer stroke frequency. The hammer will stay in high until the button is released. This position is the high speed low impact energy mode.Rotator Circuit Actuation (If Equipped)
To enable the rotator circuit, press the rear of the switch on the right console. The rotator circuit is actuated with the top left and top right buttons on the left implement control lever. The direction of rotation is dependent on the tool's hydraulic connections.High Pressure Auxiliary Circuits (If Equipped)
The high pressure auxiliary circuit is enabled when the front of the switch on the right console is pressed down. Push down on the top left button of the left implement control lever to