PANEL 2677976 - Caterpillar

Table 5
Sales Model Software Part Number
12M2 483-3705
140M2 483-3704
160M2 483-3703
D6T 486-2751
D7E 487-6050
D8T 482-9922
336E 481-8234
336E H 481-8235
349E 507-8936
735 483-3650
740 483-4183
966K 483-7468
966K XE 483-7470
972K 483-7467
980K 483-7465 Note: Factory passwords are required to install the decertification flash file.
Download the decertification flash file from Service Information System (SIS). Refer to Table 5.
Factory passwords will be issued utilizing the Dealer Solution Network (DSN).
Illustration 19 g03672156
When the decertification flash file is downloaded, this screen will appear in the electronic service tool. Refer to Illustration 19.
Click "Save to File". This action will create an HTML file.
Attach the HTML file to the DSN factory password request. Do not change the file to a PDF format.
The following text must be included in the DSN factory password request:This password request is for the decertification procedure outlined in Special Instruction, REHS9720. I acknowledge that the applicable local and national regulations permit engine serial number <enter engine serial number> to be decertified, and I will ensure export from the country if the decertified machine no longer complies with local or national regulations governing the sale and/or use of the machine. The labels to confirm that this decertification has been ordered and will be applied as per Special Instruction, REHS9720.Note: Any service requests for passwords that do not contain the above verbiage will be rejected
Once the factory passwords have been entered, install the flash file. Refer to Troubleshooting, "ECM Software - Install"Machine Labels
The certified emissions labels are located in the machine cab and on the engine block. These labels must be removed. The new decertified emissions labels must then be installed in the machine cab and on the engine block. Refer to the information below for label removal and installation instructions.Removing Adhesive Labels
Do not install the new film over the old film. Layered labels compromise label adhesion and durability. Adhesive films must be applied to a clean, dry, smooth painted surface. Surface temperature should be between 15° C (59° F) and 27° C (80.6° F).
Remove films and discard the pieces.
Clean the surface with a 1:1 mixture of isopropyl alcohol (IPA) and water. Use a clean, lint-free paper towel to remove all dirt and adhesive from the surface. Allow the surface to dry before installing the replacement films.Note: Never use acetone (propanone) to clean the engine or label surface.Applying Adhesive Labels
Carefully remove the new film from the backing. Immediately apply the label in place of removed film.Note: Avoid trapping air bubbles under the label material.
Apply pressure to entire label to ensure adhesion.
Wait at least 60 minutes before disturbing the labels.CE Plate Removal
Since a migrated machine will no longer be CE-compliant, the CE plate must be removed.Removing Spark Plug Maintenance Interval Information on 336E and 349E Excavators
Illustration 20 g03894160
Use the following steps to set the "Spark Plug" interval to "0".
Press "Service" in the main menu.
Press "Configuration".
Press "Recommended Interval".
Press "Spark Plug"
Set the interval to "0".
Use the following steps to set the "Fuel Priming Pump" interval to "Off".
Press "Service" in the main menu.
Press "Configuration".
Press "Recommended Interval".
Press "Fuel Priming Pump"
Set the interval to "Off".Note: Once the "Recommended Interval" is