PANEL GP-FUSE 3186121 - Caterpillar

Illustration 12 g06064492
(18) Low alarm, load reduction, or shutdown
(19) Low warning
(20) OK
(21) High warning
(22) High alarm, load reduction, or shutdownThe indicator bands are color-coded to show the warning/alarm/load reduction or shutdown set points that are configured.Note: The green section is configurable as off or on. This section may not show on the display. The green section will not show at all if there are no warning configured.Note: Some alarms, such as "Oil Pressure", are RPM-dependent. The bands will move as the engine speed changes.Switches
Illustration 13 g06064500
(23) Open
(24) Closed
(25) UnknownSwitches are shown as either open or closed.Note: An alarm can be configured for open or closed. The widget only shows the status of the switch.Lights
Illustration 14 g06064509
(26) OK, or Unknown
(27) Not OKWhen the lights are green, the status is "OK". When the status is "Not OK", the lights are red.Note: An "Unknown" status will show up as green.Indicator symbols
Illustration 15 g06064790
(28) Warning
(29) Alarm
(30) Derate
(31) ShutdownIf a gauge shows a parameter in an alarm state, a symbol will appear on the gauge to indicate what type of alarm is present. The symbol will remain on the gauge until the alarm is gone.Soft Keys (3)
Illustration 16 g06064845
(32) Back
(33) Forward
(34) Return to previous screen
(35) Language Selection
(36) Backlight Control (replaced by Gear Control when enabled)
(37) Start Immediately, Activate Shutdown Override Mode
(38) Activate selection for editing
(39) Gear Control (replaces Backlight when enabled)
(40) Mode Selection
(41) Ok (accept changes)
(42) Activate the selection
(43) Start the engine
(44) Cycle through the starter options. This function is only available when two starters are configured.
(45) Stop the engine
(46) Activate the next tab on the top
(47) Cycle through the options
(48) Unit SelectionThe function of the soft keys (3) at the bottom of the screen depend on the current screen selection. Refer to Illustration 16.Gear Control
Illustration 17 g06064918If "Gear Control" is enabled on the DCU, the "Backlight" soft key on the main display will be replaced with a "Gear" soft key. The "Gear" soft key navigates to the "Gear Control" screen seen in Illustration 17.Engine Speed
The "Engine Speed" gauge is the same widget found on the other screens.Shaft Speed
The "Shaft Speed" gauge refers to the propeller shaft speed. This gauge may be configured to show forward and reverse on different sides as seen in Illustration 17. The gauge may also be configured as a regular gauge like "Engine Speed".Gear
Illustration 18 g06064928
(49) Forward
(50) Reverse
(51) In Gear
(52) Neutral
(53) UnknownDepending on the DCU configuration, the "Gear" indicator may show "Forward" and "Reverse", or the indicator may only show "In Gear".When a gear change is requested, the arrow will show the current gear. The letter will flash and show the requested gear. Refer to the gear indicators in Illustration 18.RPM Interlock
Illustration 19 g06064936
RPM Interlock
(54) Active
(55) InactiveThe "RPM Interlock" indicates that the engine is turning too fast to engage the transmission. This interlock will prevent gear selection.Shaft Lock
Illustration 20 g06064940
Shaft Lock indicator
(56) Active
(57) InactiveThe "Shaft Lock" icon indicates whether the shaft lock is engaged or disengaged.Soft Keys
If the "RPM Interlock" and "Shaft Lock" are not engaged, the soft keys can be used to request a gear change.