PANEL AS 4P0420 - Caterpillar

Illustration 6 g00284786
Connect harness assembly (23) to wiper motor assembly (24) .
Illustration 7 g00284784
Tilt the steering control assembly toward the seat. Install the air duct. Tilt the air duct toward the seat so that harness clip (22) can be installed. Install the air duct in the original position.
Illustration 8 g00284782
Illustration 9 g00284780
Install bolts (21) on each side of the support assembly.
Illustration 10 g00284779
Install bolts (20) at the base of the support assembly.
Illustration 11 g00284777
Install ties (19) on the right harness assembly.
Illustration 12 g00284774
Connect harness assembly (18) to the alarm.
Illustration 13 g00284773
Install the bolt and clip (17) that secures the harness assembly on the left side of the air duct.
Illustration 14 g00284772
Install bolts (16) that secure the air duct to the cab. Repeat this step on the other side of the air duct.
Illustration 15 g00284775
Pull both harness assemblies through the openings in the air duct.
Illustration 16 g00284771
Position switch box (15). Install bolts (14) .
Illustration 17 g00984509
Install plate assembly (9). Tilt the plate assembly forward.
Connect harness assemblies (10), (11), and (12). Connect light bulbs (13) .
Illustration 18 g00984505
Tilt plate assembly (9) into position. Install screws (7) and (8). Tighten screws (7) and (8) to a torque of 1.7 0.2 N m (15 2 lb in).
Illustration 19 g00984501
Install plate assembly (2). Connect harness assemblies (3), (4) and (5). Connect light bulbs (6) .
Illustration 20 g00984497
Tilt plate assembly (2) into position. Install screws (1). The torque for screws (1) is 1.7 0.2 N m (15 2 lb in).
Put the rubber mat on the cab floor.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".