PANEL 7Y3090 - Caterpillar

Solenoid Valve for One-Way Flow and Solenoid Valves for Variable Relief
Illustration 1 g01204436
Solenoid for one-way flow and solenoids for variable relief (1) Number one line relief valve (2) Electronic check for stem 1 "(EC1)" (3) "(EC3)" Solenoid for one-way flow (4) Number two line relief valve (5) Electronic check for stem 2 "(EC2)"
Illustration 2 g01204457
(6) Electric check valves for the following "(EC1)" (2), "(EC3)" (3), and "(EC2)" (5) (7) Electric line relief valve (1), and electric line relief valve (4) There is one solenoid valve for one-way flow. When "(EC3)" solenoid for one-way flow (3) is energized, hydraulic flow is allowed to travel in only one directions. This solenoid is only present on machines that are equipped with System 14 and System 17.Attachment Solenoid Valves
Illustration 3 g01210422
Extend solenoids and retract solenoidsMachines that are equipped with the following joystick thumbwheel, joystick with four buttons, foot switch and electric foot pedal, use solenoid valves in order to control the flow of pilot oil. Pilot oil enters the valve manifold through the pressure port (P). When a solenoid receives current, the spool will shift. Pilot oil will flow out of discharge port (A(X)). After the current to the solenoid is discontinued, the valve shifts, and the pressure will drain to the tank through the drain port (T) .Solenoid Valve (Proportional Reducing)
Illustration 4 g00777019
The solenoid valve (proportional reducing) is controlled directly by the Machine ECM. The solenoid connects to C19-8. When the Controller determines the requirements for hydraulic flow, the controller sends varying signals to this solenoid.