PANEL 8P1862 - Caterpillar

Lubricate main bearing studs (8) with clean engine oil. Use Tooling (H) and a suitable torque wrench in order to check the torque on main bearing studs (8). Tighten main bearing studs (8) to a torque of 100 20 N m (74 15 lb ft). Note: Be sure that the back of the main bearing is clean and free from oil.
Lightly lubricate the upper crankshaft main bearing with clean engine oil. If necessary, use Tooling (E) in order to rotate the crankshaft and remove main bearing. Use Tooling (F) and install the upper crankshaft main bearing into the cylinder block.
Illustration 1 g01212288
Lightly lubricate crankshaft main bearing (7) with clean engine oil. Install crankshaft main bearing (7) into crankshaft main bearing cap (6). Lift crankshaft main bearing cap (6) into position.
Illustration 2 g01212278
Lubricate bolts (5) with clean engine oil. Remove Tooling (G). Install bolts (5) finger tight.
Illustration 3 g01212274
Lubricate the main bearing studs with clean engine oil. Install plate (4). Install nuts (3) for the crankshaft main bearings finger tight.
Illustration 4 g01212278
Start at the front of the engine and tighten bolts (5) on the right side of the cylinder block to a torque of 100 20 N m (74 15 lb ft).
Illustration 5 g01212105Note: Show 14 to 15 threads or 28 to 30 mm of protrusion of the stud above the nut before tension is applied. Show 16 to 17 threads or 32 to 34 mm of protrusion of the stud above the nut after tension is applied.
Install Tooling (A) onto the studs for the crankshaft main bearing cap. Tighten the threaded collar of Tooling (A). Loosen the threaded collar of Tooling (A) by 1 1/2 turns. Attach Tooling (B) onto Tooling (A). Attach Tooling (C) onto Tooling (D). Apply approximately 135 MPa (19580 psi) of pressure to Tooling (B). Use the drive on Tooling (A) in order to tighten the nuts for the crankshaft main bearings. Release the pressure on Tooling (A). Reapply approximately 135 MPa (19580 psi) of pressure to Tooling (A). Recheck nuts (3) for tightness. Remove Tooling (A).
Illustration 6 g01212278
Start at the front of the engine and tighten bolts (5) on the left side of the cylinder block to a torque of 100 20 N m (74 15 lb ft).
Illustration 7 g01212278
Start at the front of the engine and tighten bolts (5) on the right side of the cylinder block to a torque of 530 70 N m (391 52 lb ft).
Start at the front of the engine and tighten bolts (5) on the left side of the cylinder block to a torque of 530 70 N m (391 52 lb ft).
Illustration 8 g01212026
Install side cover (2). Install bolts (1). Repeat for the remaining side covers on both sides of the engine. End By:
Install the engine oil scavenge pump. Refer to Disassembly and Assembly, "Engine Oil Scavenge Pump - Install".
Install the engine oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler - Install".
Install the engine oil pump. Refer to Disassembly and Assembly,