PEDAL 1062433 - Caterpillar

Illustration 1 g00761921
(1) Lubricate the bore lightly with the lubricant that is being sealed. (2) The connections for the hose should be tested for leaks at a pressure of 690 140 kPa (100 20 psi). The test should be done before the final installation of the differential and bevel gear group. (3) Apply 4C-5593 Anti-Seize Compound to the washer faces and threads before assembly. Tighten the 36 bolts to a torque of 440 14 N m (325 10 lb ft). (4) Torque for four bolts ... 1100 100 N m (811 74 lb ft) (5) These surfaces must be free of lubricant.
Illustration 2 g01054491
View A-A (6) Lubricate the bore lightly with the lubricant that is being sealed. (7) 9M-5874 Shim Pack Shim pack thickness ... 3.30 mm (0.130 inch) Measure the length of pin that is extended past the mounting surface. Install the shims to the given dimensions. ... minus 0.05 + 0.03 mm (0.002 + 0.001 inch)Note: The shim pack must be flat. The shim pack must be free of dents and wrinkles. (8) 7D-4893 Spring Quantity ... 16 Test length ... 68.3 mm (2.69 inch) Test force ... 425.7 21.4 N (95.70 4.80 lb) Free length after test ... 75.7 mm (2.98 inch) Outside diameter ... 23.80 mm (0.937 inch) (9) Torque for 12 bolts ... 135 20 N m (100 15 lb ft) (10) Lubricate the sealing lip with the lubricant that is being sealed. (11) 8X-1061 Shim Quantity ... 6 Thickness ... 0.178 0.013 mm (0.0070 0.0005 inch) (12) 8X-1062 Shim Quantity ... 8 Thickness ... 0.127 0.013 mm (0.0050 0.0005 inch)Note: Refer to Testing and Adjusting, "Differential and Bevel Gear - Adjust" for preloading the pinion bearings.