PEDAL-RUBBER 1257358 - Caterpillar

Check the Wires for Damage to the Insulation
Carefully inspect each wire for signs of abrasion, of nicks, and of cuts. Inspect the wires for the following conditions:
Exposed insulation
Rubbing of a wire against the chassis
Rubbing of a wire against a sharp point
Table 2
Troubleshooting Test Steps    Values    Results    
1. Check All Wiring Harness Fasteners
A. Check all of the fasteners to verify that the harness is secure and is NOT compressed.
B. Pull back the harness sleeves to check for a flattened portion of wire. (A fastener that has been overtightened will flatten the harness.)    
The wires are free of abrasion, of nicks, and of cuts and the harness is properly clamped.     OK - The harness has passed all checks.
Proceed to "Inspect the Connector Terminals".
NOT OK - There is damage to the harness.
Repair: Repair the wires or replace the wires, as required. Verify that the repair eliminates the problem.
STOP.    Inspect the Connector Terminals
Table 3
Troubleshooting Test Steps    Values    Results    
1. Visually inspect each terminal in the connector.
A. Verify that the terminals are not damaged. Verify that the terminals are properly aligned in the connector and verify that the terminals are properly located in the connector.    
The terminals are properly aligned and the terminals appear undamaged.     OK - The terminals show no signs of damage.
Proceed to "Perform a Pull Test on Each Wire Terminal Connection".
NOT OK - The terminals of the connector are damaged.
Repair: Repair the terminals and/or replace the terminals, as required. Verify that the repair eliminates the problem.
STOP.    Perform a Pull Test on Each Wire Terminal Connection
Illustration 3 g02732798
(4) Locking Wedge for 3-pin connector
Table 4
Troubleshooting Test Steps    Values    Results    
1. Check Locking Wedge Of Connector.
A. Ensure that the locking wedge for the connector is installed properly. (Refer to the figure above.)
B. Perform the
45 N (10 lb) pull test on each wire. (Each terminal and each connector should easily withstand
45 N (10 lb) of tension and each wire should remain in the connector body.)    
This test confirms that the wire was properly crimped in the terminal and the terminal was properly inserted into the connector.     OK - All terminals pass the pull test.
Proceed to "Check Individual Pin Retention into the Socket".
NOT OK - A wire has been pulled from a terminal or a terminal has been pulled from the connector.
Repair: Use the 1U-5804 Crimp