PEDAL GP-GOVERNOR 1308176 - Caterpillar

Safety precautions and warnings are provided in this manual and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons.The hazards are identified by the safety alert symbol which is followed by a signal word such as danger, warning, or caution. The "" safety alert symbol is shown below.
Illustration 2 g00008666
This safety alert symbol means:Pay attention!Become alert!Your safety is involved.The message that appears under the safety alert symbol explains the hazard. Operations that may cause product damage are identified by "" labels on the product and in this publication.Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The safety information in this document and the safety information on the machine are not all inclusive. You must determine that the tools, procedures, work methods, and operating techniques are safe. You must determine that the operation, lubrication, maintenance, and repair procedures will not damage the machine. Also, you must determine that the operation, lubrication, maintenance, and repair procedures will not make the machine unsafe.The information, the specifications, and the illustrations that exist in this guideline are based on information which was available at the time of publication. The specifications, torques, pressures, measurements, adjustments, illustrations, and other items can change at any time. These changes can affect the service that is given to the product. Obtain the complete, most current information before you start any job. Caterpillar dealers can supply the most current information.Part Description
Table 2
Base Metal     Steel    
Hardness     N/A    Flame Spray Equipment and Procedure
Table 3
Maximum Surface Finish     0.51 µm (20.000 µin)    
Reason for Spraying     Wear, Bearing Failure    
Mating Part Contact Area & Material     Bearing    
Metco Equipment Type     6P-II    
Metco Material     447 or 453    
Finished Thickness     As required    
Finishing Allowance    
0.25 mm (0.010 inch) per side    
Spray Angle     90° to part    
Substrate Pre-Heat Temperature    
38° C (100° F)    
Substrate Temperature During Spraying Not to Exceed    
260° C (500° F)    
Auxiliary Cooling     AJ    
Rotation/Traverse Device     Lathe    
Rotation/Traverse Speed    
91.44 SMPM (300.000 SFPM) minimum    
Surface Preparation Method     Grit Blast    
Finishing Method     Grind    
Grinding Equipment Type     Cylindrical or tool post    
Recommended Wheel     46J or 46K silicon carbide    
Table 4
Flame Spray Process (6P)     Procedure     Check List    
Clean part     Metco Cleaning Solvent