PEDAL AS 1380240 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7573     Link Bracket     2    Start By:
Release system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the work tool hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01160707
Remove plate assemblies (2). Disconnect hose assemblies (1). Disconnect hose assemblies (3) .
Illustration 2 g01160708
Disconnect harness assemblies (4) and (5) .
Illustration 3 g01160709
Attach Tooling (A) and a suitable lifting device to main control valve (7). The weight of main control valve (7) is approximately 80 kg (176 lb). Remove bolts (6) and main control valve (7) .