PEDAL GP-GOVERNOR 1641078 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g03360300The hydraulic filter is located on the right side of the machine under the platform.
Use a strap type wrench to remove filter element. Dispose of the used filter element properly.
Clean the filter mounting base. Make sure that all of the used seal is completely removed.
Illustration 2 g00101318
Apply a thin coat of hydraulic oil to the seal on the new filter. Install new hydraulic oil filter hand tight until the seal of the hydraulic oil filter contact filter base. Note the position of the index marks on filter in relation to a fixed point on filter base. Note: There are rotation index marks on hydraulic oil filter that are spaced 90 degrees or 1/4 of a turn away from each other. When you tighten the hydraulic oil filter, use the rotation index marks as a guide.
Tighten filter according to the instructions that are printed on filter. Use the index marks as a guide. For non-Caterpillar filters, use the instructions that are provided with the filter. Note: You may need to use a Caterpillar strap wrench, or another suitable tool, in order to turn the filter to the amount that is required for final installation. Make sure that the installation tool does not damage the filter.
Start the engine and run the engine at low idle. Inspect the hydraulic system for leaks.
Illustration 3 g01185406
Maintain the oil level above the "ADD COLD" mark on the sight gauge. Add hydraulic oil, if necessary.