PEDAL-CLUTCH 2074922 - Caterpillar

Illustration 7 g06017531
Remove bolts (14).
Illustration 8 g06017533
Typical example
Attach Tooling (A) and a suitable lifting device to differential and bevel gear (15). The weight of differential and bevel gear (15) is approximately 750 kg (1653 lb).Note: Bolts (14) can be used as forcing bolts in the following step.
Install two of bolts (14) in the threaded holes of differential and bevel gear (15). Tighten the bolts evenly to separate differential and bevel gear (15) from the axle housing. Remove differential and bevel gear (15).
Illustration 9 g06017537
Remove O-ring seal (16) from differential and bevel gear (15).Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 439-3941 Link Bracket 3
B 1U-7234 Feeler gauge 1
Thoroughly clean the mating surfaces of the differential and bevel gear and of the axle housing. Replace O-ring seals with the new parts.
Illustration 10 g06017537
Install O-ring seal (16) on differential and bevel gear (15).
Illustration 11 g06017541
Typical example
Use Tooling (A) and a suitable lifting device to install differential and bevel gear (15). The weight of differential and bevel gear (15) is approximately 750 kg (1653 lb). Install differential and bevel gear (15).
Illustration 12 g06017531
Install bolts (14). Tighten bolts (14) to a torque of 750 90 N m (553 66 lb ft).
Illustration 13 g06017530
Install temperature sensor assembly (12) and bracket assembly (13).
Illustration 14 g06017527
Position bracket (10) and all the tubes as one unit.
Install bolts (8). Tighten bolts (8) to a torque of 750 90 N m (553 66 lb ft).
Connect tube assemblies (9) to each service brake unit.
Connect angle clips (9).
Illustration 15 g06017525
Install guard assemblies (6) and (7).
Illustration 16 g06017524
Install O-ring seal (5) and pin (4).
Illustration 17 g06017542
Install cover (3) without shim. Install bolts (1). Tighten bolts (1) enough to remove the end play between the pin and cover (3).
Use Tooling (B) to measure the gap between cover (3) and the axle housing. Record the measurement. Use the measurement to determine the correct thickness of required shims.
Install a thickness of shims that will establish a −0.03 mm (−0.001 inch) preload to a 0.03 mm (0.001 inch) end play in the pin.
Illustration 18 g06017522
Install cover (3) with the measured number of shims (2). Install bolts (1). Tighten bolts (1) to a torque of 135 20 N m (100 15 lb ft).
End by:a. Install the Axle Shaft.b. Install the Fixed Axle (Front).