PILOT ASSEM. 5K1278 - Caterpillar

Starting fluid is required for temperatures below 0 °C (32 °F). The use of other optional cold starting aids is recommended for temperatures below −18 °C (0 °F).Heaters
Note: Oil pan immersion heaters are not recommended for heating the lube oil. To ensure the compatibility of the components, only use equipment that is recommended by Caterpillar.Starting capabilities will be improved at temperatures below 12 °C (55 °F) with a starting aid. A jacket water heater may be needed and/or the crankcase oil may need warmed.Note: The fluid that is heated must circulate continuously. This circulation will help prevent localized overheating of the fluid.A jacket water heater is available as an option for starting in temperatures as low as 0 °C (32 °F). The jacket water heater can maintain the water temperature at approximately 32 °C (90 °F). The heated water will help to keep the oil in the engine block warm enough to flow when the engine is started.When No. 2 diesel fuel is used, a fuel heater will maintain the temperature of the fuel above the cloud point. Fuel line insulation will help to maintain the fuel temperature.Consult your Caterpillar dealer for more information on the starting aids that are available for cold weather starting.Starting With Ether
Personal injury or property damage can result from alcohol or starting fluids.Alcohol or starting fluids are highly flammable and toxic and if improperly stored could result in injury or property damage.
The optional ether starting aid is the only system that is recommended for the injection of starting fluid.Perform the procedures that are described in this Operation and Maintenance Manual, "Before Starting Engine" topic (Operation Section).
Ensure that the driven equipment is unloaded. Place the transmission in neutral.
Move the throttle so that fuel is provided to the engine.
Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again.
Crank the engine. Use of the starting aid depends on these conditions:
The engine control module controls the duration of automatic ether injection in these circumstances:
The jacket water coolant temperature is between −40 to 30 °C (−40 to 86 °F).
The engine rpm is more than 75 rpm and less than 400 rpm.
Manual ether injection can be performed in these circumstances:
The momentary contact switch for the ether injection is activated.
The jacket water coolant temperature is between −40 to 30 °C (−40 to 86 °F).
The engine rpm is more than 75 rpm and less than 400 rpm.
Excessive starting fluid can cause piston and ring damage.Use starting fluid for cold starting purposes only.Do not use excessive starting fluid during starting or after the engine is running.
To inject ether manually, press the starting aid switch. Release the switch immediately.Additional injections may be necessary in order to start the engine. Press the starting aid switch about every 2 seconds until the engine begins to idle smoothly.