AVSPARE.COM
parts catalog

PIN-ROD END 0000208 - Caterpillar



0000208 PIN-ROD END Caterpillar parts PIN
Rating:
16
Alternative (cross code) number:
CA0000208
000-0208
0000208
Caterpillar 0000208 PIN-ROD END

Buy PIN-ROD END 0000208 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g00299479
Display AreaNumeric readout mode is an operator mode. Numeric readout mode assists service personnel with troubleshooting of sensor inputs. The inputs supply information for the gauges in the quad gauge modules. Numeric readout mode more accurately shows the same information that is shown on the gauges in normal mode. The system identifier and the numeric value for the system scrolls on the six digit display area. The system identifier identifies the system that is currently shown on the six digit display area. See table 1 for "System Identification" and illustration 2 in order to match the system identifier to the appropriate gauge. Note: Custom applications on some machine models will scroll to system identifiers GA-5 and GA-6. These system identifiers represent machine system information that is only displayed in the six digit display area and is not represented by a gauge.
Illustration 2 g00537627
Quad gauge modules
Illustration 3 g00299481
This is an illustration of the display area on the Main Display Module that is showing an example of a system identifier.
Table 1
System Identification    
System Identifier    Gauge (System)    
GA-1     Coolant Temperature    
GA-2     Torque Converter Temperature    
GA-3 (1)     Air Pressure    
GA-4     Fuel    
GA-5     Engine Oil Pressure    
GA-6     Inlet Air Temperature    
( 1 ) In D6III and D7RII D/S models and 572RII, GA-3 is Hydraulic Oil Temperature
Table 2
Units    
Condition    Units of Measurement    
Temperature     °C    
Pressure     kPa    
Voltage     0.1 volts    
Level     % full    Only the gauge for the system that is shown on the six digit display area is operational. All other gauges in the quad gauge module are shut off. The gauge needles will move to the far left position.When you enter the numeric readout mode, the six digit display area is showing information for system GA-1. The display momentarily shows the system identifier. The display then shows the value for the corresponding system on the six digit display area. Scroll through the gauges by momentarily pressing the operator mode switch. Toggle the operator mode switch quickly. When the service input is grounded, all of the systems will scroll on the display. This will show the system identifiers. Removing ground from the service input stops the scrolling, when the desired system is shown. The six digit display area continues to show the system identifier momentarily. The six digit display area then shows the value of the system. The system is now shown on hold. While the system is on hold, the numeric value of the system is continuously updated.


Parts pin Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.