AVSPARE.COM
parts catalog

PIN-ROD END 0000907 - Caterpillar



0000907 PIN-ROD END Caterpillar parts PIN
Rating:
11
Alternative (cross code) number:
CA0000907
000-0907
0000907
Caterpillar 0000907 PIN-ROD END

Buy PIN-ROD END 0000907 Caterpillar genuine, new aftermarket tractor parts with delivery

You can buy parts: .

$70.46

19 Nov 2019
0.01 ounces
-: -
Allied Titanium 0000907, (Pack of 25) #10 Titanium Lock Washer, Grade 5 (Ti-6Al-4V)
#10 Allied Titanium Lock Washer || TRUE TITANIUM(TM) - Stronger, Lighter and Corrosion Free || Titanium is good for use in or near saltwater || General Tolerance: +/- 0.003 inch || Meets ASME B18.21.1; Grade 5 (Ti-6Al-4V) Titanium with Polished Finish
  For full view, you need register

Information:

Which Generate This Code:This diagnostic code is recorded when the ECM reads the system voltage as being greater than 16 DCV.The possible causes of this diagnostic code are listed:
A charging system component has failed.
The wiring of the machine harness has failed.
The ECM has failed. This is unlikely.System Response:When this diagnostic code occurs, the action lamp and the action alarm is ON. The diagnostic code will cause the transmission to shift to NEUTRAL until the diagnostic code is corrected.Test Step 1. CHECK THE CHARGING SYSTEM.
Turn the disconnect switch and the key start switch to the ON position.
Place CID 0168 FMI 03 on hold. See Troubleshooting, "Using the Diagnostic Indicator to Determine Diagnostic Codes".
View the status of the diagnostic code.Expected Result:The diagnostic code is NO longer active.Results:
YES - The diagnostic code is NO longer active. Proceed to test step 2.
NO - The diagnostic code remains active. Proceed to test step 3.Test Step 2. CHECK THE CHARGING SYSTEM AGAIN.
Start the engine.
Place CID 0168 FMI 03 on hold.
View the status of the diagnostic code.Expected Result:The diagnostic code is NO longer active.Results:
YES - The diagnostic code is NO longer active. Watch for a recurrence.STOP
NO - The diagnostic code is active. The charging system is charging at an excessive voltage. Repair: Check the charging system. See Special Instruction, REHS0354, "Charging System Troubleshooting" for more information.STOPTest Step 3. CHECK THE BATTERY VOLTAGE.
The engine should not be running.
At the battery, measure the voltage of the battery.Expected Result:The voltage should measure less than 16 DCV.Results:
YES - The voltage measures less than 16 DCV. The ECM must be recording this diagnostic code incorrectly. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is NOT found, replace the ECM. SeeTesting and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NO - The voltage measurement is greater than 16 DCV. The charging system is charging at an excessive voltage.Repair: Check the charging system.STOP


Parts pin Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.