PIN-SPRING 0950893 - Caterpillar

Check the condition of the O-ring seals. If the O-ring seals are damaged, use new parts for replacement.
Illustration 1 g00890198
Illustration 2 g01276417
Note: Install flange (11) with alignment pin (11A) between the bolt holes.
Apply a thin coat of Tooling (E) on the outside machined surface of flange (11). Apply a thin coat of Tooling (E) in the bore of flange (11). Install flange (11) in the bucket.
Temporarily install the O-ring seals (not shown) on each flange of the bucket at the pin bore for the stick. Start the engine, and lower the stick into the bucket until the pin bores are in alignment with each other. Stop the engine.
Illustration 3 g01280867
Make sure that the threaded puller hole in the end of bucket pin (10) is clean. Apply a thin coat ofTooling (E) on bucket pin (10). Install Tooling (C) in the end of bucket pin (10). Use a suitable lifting device in order to position bucket pin (10) and install the pin with a hammer. Remove Tooling (C). The weight of bucket pin (10) is approximately 107 kg (235 lb).
Illustration 4 g00890207
Illustration 5 g00889666
Install plate (13) with shims (12). Install bolts (14) and tighten the bolts evenly.
Move the bucket to one side until the bucket contacts the stick. Measure the clearance between the bucket and the stick at flange (11). Record this dimension. Add or remove shims (12) between plate (13) and flange (11) until clearance (X) between the stick and the bucket is between 0.5 mm (0.02 inch) to 1.0 mm (0.04 inch). Refer to figure 5 for clearance (X) .
If shims were added or removed, reinstall plate (13). Install bolts (14). Tighten bolts (14) evenly.Note: There are two different thicknesses of shims. Only use a minimum of three 7Y-7829 Shims (12) .
Illustration 6 g00889682
Position plate (9) and install bolts (8) .
Illustration 7 g00884879
Slide O-ring seals (7) off the pin joints between the stick and the bucket and onto the flanges on the bucket.
Illustration 8 g00884729
Slide O-ring seals (3) off the pin joints between the bucket and link assembly (4) and onto the flanges of the bucket.
Illustration 9 g00889696
Make sure that the threaded puller hole in the end of bucket pin (6) is clean. Apply a thin coat ofTooling (E) to the surface of bucket pin (6). Install Tooling (D) in the end of bucket pin (6). Use a suitable lifting device in order to position bucket pin (6) and install bucket pin (6) with a hammer. Remove Tooling (D) from bucket pin (6). The weight of bucket pin (6) for the H-Family Bucket is approximately 93 kg (205 lb). The weight of bucket pin (6) for the J-Family Bucket is approximately 80 kg (175 lb).Note: Use Tooling (C) for the H-Family Bucket. Use Tooling (D) for the J-Family Bucket.
Illustration 10 g00884725
Position plate (2) and install bolts (1) .
Slide O-ring seals (3) over the pin joints between the bucket and link assembly.
Lubricate the bucket pins. Refer to Operation and Maintenance Manual, "Boom, Stick and Bucket Linkage - Lubricate".