AVSPARE.COM
parts catalog

PIN 1076560 - Caterpillar


1076560 PIN Caterpillar parts 311, 311B, 312, 315, 317, OEMS
Rating:
25
Alternative (cross code) number:
CA1076560
107-6560
1076560
Caterpillar 1076560 PIN
Weight: 0.03 pounds 0 kg.

Buy PIN 1076560 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, UNDERCARRIAGE,

Compatible equipment models: 1076560:

EXCAVATOR  311   311B   312   315   317  
UNDERCARRIAGE  OEMS   Caterpillar
Number on catalog scheme: 2
  For full view, you need register

Information:


Illustration 1 g00607754
Schematic of the Swing Brake SolenoidThis diagnostic code is associated with the Swing Brake Solenoid. The FMI 05 means that the ECM has determined that an open in the circuit exists. The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0374 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the solenoid with the active diagnostic code from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire K907-BU) to contact 2 (wire E790-PK).
Observe the status of the CID 0374 FMI 05.Expected Result:The CID 0374 FMI 05 remains active. The FMI has not changed and the "05" is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem. Stop.Test Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
The jumper wire that was installed in the previous Test Step remains in place.
At the machine harness connector, measure the resistance from signal contact J2-19 (wire K907-BU) to contact J2-37 (wire E790-PK).Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire K907-BU or in wire E790-PK of the machine harness. Repair the machine harness or replace the machine harness. Stop.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0374 FMI 05.Expected Result:The CID 0374 FMI 05 is active. Results:
YES - The CID 0374 FMI 05 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Electronic Control

Caterpillar parts catalog:

Caterpillar parts catalog
CIPI Undercarriages L5E00001-UP (MACHINE)
312 Excavator Custom Attachments 6BL00001-UP (MACHINE)
315 Excavator 3ZM00001-UP (MACHINE) POWERED BY 3054 Engine
317 & 317N Excavators 4MM00001-UP (MACHINE) POWERED BY 3054 Engine


Parts pin Caterpillar catalog:

9B2289 PIN
215, 215B, 225, 227, 229, 235, 235C, 245, 517, 527, 561B, 561C, 561M, 561N, 571G, 572G, 572R, 572R II, 583H, 583K, 594, 594H, 939, 939C, 941, 943, 951B, 953, 953B, 953C, 953D, 955C, 955H, 955K, 955L, ...
6B5502 PIN-TRACK
215B, 225, 229, 561B, 561C, 951B, 955C, 955H, 955K, 955L, 977D, D5, D5B, FB221, OEMS
8E4272 PIN-TRACK
235C, 325D FM, 325D FM LL, 330C, 330C FM, 330D FM, 330D L, 330D MH, 345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 36...
1039679 PIN-PISTON
315, 315B, 933, 933C, D3C III, D4C III, D5C III
1607819 PIN-TRACK
527, 963B, 963C, 963D, D6E, D6E SR, D6G, D6G SR, D6G2 LGP, D6G2 XL, D6H, D6H XL, D6H XR, D6M, D6R, D6R II, OEMS
1141541 PIN-DOWEL
325 L, 328D LCR, 330, 330 L, 330B, 330B L, 330C, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 ...
6Y2266 PIN
1090, 1190, 1190T, 1390, 2290, 2390, 2391, 320 L, 320B, 320C, 322B L, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D FM, 324D FM LL, 324D L, 324E L, 325, 325 FM L, 325 L, 325 LN, 325B, 325B L, 325C, 32...
6Y0851 PIN-TRACK
320B, 320C, 322 FM L, 322B L, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D FM, 324D FM LL, 325, 325 L, 325 LN, 325B, 325B L, 325C, 325C FM, 325C L, 325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 329E,...
5I8420 PIN
320 L, 320B, 320B L, 320N, 345B, 345B L, OEMS
1883065 PIN-TRACK MASTER
320C, 322C, 322C FM, 323D LN, 323D SA, 325B L, 325C, 325C FM, 325C L, 325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 330C, 330C L, 330D, 330D L, 336D L, 336D LN, 336E, 345C, 345D, 349D L, OEMS
6Y8029 PIN-SPRING
1290T, 1390, 2491, 2590, 325C, 328D LCR, 330, 330 FM L, 330 L, 330B, 330B L, 330C, 330C FM, 330C L, 330C MH, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E H...
6Y2748 PIN-TRACK MASTER
1290T, 1390, 2491, 2590, 330, 330 FM L, 330 L, 330C FM, 330C L, 330D, 330D L, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L,...
5W3581 PIN
205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B, 312, 312B L, 315, 317
1R6227 PIN
311, 311B, 312, 312B, 312B L, 312C, 312C L, 313B, E110B, E120B
1174444 PIN
312, 312B L, 312C, 312D
7Y5757 PIN
307, 312, 315, 317, 320 L, 322 FM L, 325, 325 L, 325 LN, 330, 330 FM L, 350, 375, 375 L, E240C
7Y4717 PIN
307, 312, 315, 317, 320 L, 322 FM L, 325, 325 L, 325 LN, 330, 330 FM L, 350, 375, 375 L
7Y7685 PIN
312, 315, 315B FM L, 317, 320 L, 320B, 320N, 322 FM L, 322B L, 322C, 325, 325 LN, 325B, 325B L, 325C, 330, 330B L, E240C
0859769 PIN
311, 311B, 311C, 311D LRR, 311F LRR, 312, 312B L, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313B, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315, 316...
0937919 PIN
311, 311B, 312, 312B, 315, 315B, 315B FM L, 317, E110, E110B, E140, OEMS
0997147 PIN
311, 311B, 312, 312B, 315, 315B, 315B FM L, 317, E110B, OEMS
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.