1079852 PIN AS Caterpillar parts
315, 315B, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318D L, 318D2 L, 318E L
Rating:
Alternative (cross code) number:
CA1079852
107-9852
1079852
CA1079852
107-9852
1079852
Weight: 12 pounds 5 kg.
Information:
PIN LENGTH
154
mm
PIN OUTER DIAMERTER
69.85
mm
PIN PART NUMBER
1079853
PLATE PART NUMBER
4I3456
LUBE OUTLET
N
PIN END TYPE
CHAMFER
PIN TRANSV HOLE
N
PLATE FIXING HOLES
Y
EXCAVATOR,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$76.93
31 Mar 2019
REPLACEMENT CATERPILLAR: REPLACEMENT CAT
CATERPILLAR 1079852 PIN A NEW
$76.75
19 Aug 2021
12.3[5.54] Pounds
US: IronDT
CTP Caterpillar Pin a (1079852) Aftermarket
CTP
CTP
$70.95
30 Aug 2017
5.00[2.25] pounds
Toro: Toro
Toro Shield Lower Asm Part # 107-9852
Toro Shield Lower Asm Part # 107-9852
Toro Shield Lower Asm Part # 107-9852
Number on catalog scheme:
4
For full view, you need register
Compatible equipment models: 1079852:
Information:
The condition of charge in the battery at each regular inspection will show if the charging system operates correctly. An adjustment is necessary when the battery is constantly in a low condition of charge or a large amount of water is needed. A large amount of water would be more than one ounce of water per cell per week or per every 100 service hours.When it is possible, make a test of the charging unit and voltage regulator on the engine, and use wiring and components that are a permanent part of the system. Off-engine testing or bench testing will give a test of the charging unit and voltage regulator operation. This testing will give an indication of needed repair. After repairs are made, perform a test to prove that the units have been repaired to the original condition of operation.See Special Instruction, REHS0354, "Charging System Troubleshooting" for the correct procedures to use to test the charging system. This publication also contains the specifications to use when you test the charging system.To check for correct output of the alternator, see the Specifications module.Before the start of on-engine testing, the charging system and the battery must be checked according to the following steps.
The battery must be at least 75 percent (1.225 Sp Gr) of the full charge. The battery must be held tightly in place. The battery holder must not put too much stress on the battery.
Cables between the battery, the starter, and the engine ground must be the correct size. Wires and cables must be free of corrosion. Wires and cables must have cable support clamps to prevent stress on battery connections (terminals).
Leads, junctions, switches, and panel instruments that have direct relation to the charging circuit must give correct circuit control.
Inspect the drive components for the charging unit to be sure that the components are free of grease and oil. Be sure that the drive components have the ability to operate the charging unit.
The battery must be at least 75 percent (1.225 Sp Gr) of the full charge. The battery must be held tightly in place. The battery holder must not put too much stress on the battery.
Cables between the battery, the starter, and the engine ground must be the correct size. Wires and cables must be free of corrosion. Wires and cables must have cable support clamps to prevent stress on battery connections (terminals).
Leads, junctions, switches, and panel instruments that have direct relation to the charging circuit must give correct circuit control.
Inspect the drive components for the charging unit to be sure that the components are free of grease and oil. Be sure that the drive components have the ability to operate the charging unit.
Cat SIS web machinery list:
Parts pin Caterpillar catalog:
312D, 312D L, 312D2 L, 315C, 317B LN, 318B, 318C, 320 L, 320B, 320C, 321D LCR, 322B L, 322B LN, 322C, 325B L, 325C, 330, 330 FM L, 950F, 950G, 953C, 963, 963C, M312, M315, M318, M320
315B, 315B FM L, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320B, 320B U, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, ...
307C, 308C, 311, 311B, 311C, 311D LRR, 311F LRR, 312B, 312C, 312C L, 312D, 312D2, 312D2 GC, 312E, 313B, 313D, 313D2, 313D2 LGP, 314C, 314D LCR, 314E CR, 314E LCR, 315C, 316E L, 320B, 320C, 320C L, 320...
315B L, 315C, 317B LN
315B L, 315C, 317B LN
311C, 313D2 LGP, 315C, 315D L, 316E L, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR,...
318B, 318C, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320B FM LL, 320B L, 320B U, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC...
311, 311B, 311C, 311D LRR, 312B, 312C, 312C L, 312D, 312D L, 313D, 314C, 314D CR, 314D LCR, 315D L, 318C, 318D L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D F...
301.6C, 302.5C, 303, 304, 311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321D LCR, 323D...
16, 315D L, 316E L, 318D2 L, 318E L, 319D L, 319D LN, 320D, 320D GC, 320D L, 320D LRR, 320D RR, 320D2, 320E, 320E L, 320E LN, 320E LRR, 321D LCR, 323D L, 323D LN, 323D SA, 323E L, 324D, 324D L, 324E, ...
315, 315B, 933, 933C, D3C III, D4C III, D5C III
315C, 315D L, D3B, D3C, D3C II, D3C III, D3G, D3K XL, D3K2 LGP, D4C, D4C II, D4C III, D4G, D4K XL, D4K2 XL, D5C, D5C III, D5G, D5K LGP, D5K2 XL
315, 315B, 315C, 315D L, 316E L, 317, 318D L, 318D2 L, 318E L
315, 315B, 315C, 315D L, 316E L, 317, 318D L, 318D2 L, 318E L, G107B, M312, M313C, M313D, M315, M315C, M315D, M316C, M316D, PIN GRAB
315, 315B, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318D L, 318D2 L, 318E L
1219525
PIN AS
315, 315B L, 315C, 317, 317B LN
315, 315B L, 315C, 317, 317B LN
1237967
PIN AS
315, 315B L, 317, 317B LN
315, 315B L, 317, 317B LN
315, 315B, 315B L, 315C, 317, 317B LN
1102170
PIN
M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318, M318C, M318D, M318D MH
M312, M313C, M313D, M315, M315C, M315D, M315D 2, M316C, M316D, M317D 2, M318, M318C, M318D, M318D MH
5W8639
PIN
205, 205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B, M312, M315, M318, M320
205, 205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B, M312, M315, M318, M320
1233884
PIN
M312, M315, M318, M320
M312, M315, M318, M320
1308581
PIN AS
M312, M315, M318
M312, M315, M318
215B, 311C, 311F LRR, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312E, 312E L, 313D, 313D2, 314C, 314E CR, 314E LCR, 315, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318C, 318D L, 318D2 L, 320B, 320...
115, 315, 315B, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D LN, 320B, 320C, 320C L, 320D, 320D GC, 320D L, 320D LRR, 320D RR, 320D2, 320D2 GC, 320...