PIN 1090367 - Caterpillar

Illustration 1 g02570597
Right side view
Table 1
Specification for 160-8328 Oil Pan Gp    
Item     Qty     Part     Specification Description    
1     1     188-0210 Gasket     Apply ultra blue Loctite 587 on the top across the entire length of joints of the oil pan gasket as shown in Illustration 1.    
2     1     5P-5846 O-Ring Seal     Lubricate the bore lightly with the lubricant that is being sealed.    
3     1     5P-8068 O-Ring Seal     Lubricate the bore lightly with the lubricant that is being sealed.    
4     3     9X-6451 Drain Plug     Torque to
70 15 N m (50 11 lb ft).    
Illustration 2 g02570596
Table 2
Specification for 109-3287 Oil Pan Gp    
Item     Qty     Part     Specification Description    
        Use the following procedure during assembly of engine oil pan:    
        Note: The sealing surfaces of the oil pan shall be free of oil, debris, gasket material, or any other sealant.    
        Note: The oil pan must be assembled and tightened to the cylinder block within10 minutes of applying sealant.    
        1. Apply
3 to 5 mm (0.1 to 0.2 inch) of ultra blue Loctite 587 to the following locations:
Connecting joint of the front housing and the front of the cylinder block.
Connecting joint of the flywheel housing and the rear of the cylinder block.    
        2. Tighten bolt 1 through bolt 40 in the numerical sequence as shown in Illustration 2 to
40 5 N m (30 4 lb ft)    
        2. Again, tighten bolt 1 through bolt 40 in the numerical sequence as shown in Illustration 2 to
47 5 N m (35 4 lb ft)