PIN AS 1254979 - Caterpillar

Illustration 1 g00280782
Connections for the Caterpillar Electronic Technician (ET)The following components are needed to use CAT ET: (1) IBM compatible personal computer with an installed current version of Caterpillar Electronic Technician software (2) 139-4166 Data Link Cable or 7X-1570 Data Link Cable (3) 7X-1425 Cable and 4C-6805 Adapter (4) Special Publication, JEBD3003, Special Publication, JERD2124, Special Publication, JERD2129 Caterpillar Electronic Technician software (5) 7X-1700 Communication Adapter Tool and Special Publication, NEXG4323, "Compatible Adapter Software"Note: Caterpillar Electronic Technician (ET) is a software program that can be used on an IBM compatible personal computer. Reference: In order to use the CAT ET, order the following materials: Special Publication, JERD2124, "ET Single Use Program License", Special Publication, JEHP1026, "Information and Requirements Sheet", Special Publication, JERD2142, "Data Subscription" and 7X-1425 Data Link Cable. The Special Publication, JEHP1026, "Information and Requirements Sheet" lists the required hardware and the features of CAT ET.The service tool (ET) is not needed in order to determine diagnostic codes. However, the process of determining diagnostic codes is easier with the CAT ET. The ET can also display information on the diagnostic code history and the parameter status. These features allow the ET to be a useful tool for troubleshooting.The CAT ET will connect to the machine service connector in order to communicate with the electronic control modules over the data link. The service connector is located behind the access cover of the fuse panel in the right interior panel of the cab. For more information and the locations of the connectors, see Testing and Adjusting, "Electrical Components and Connector Locations" and the Electrical System Schematic in your machine's Service Manual.