PIN 1382482 - Caterpillar

Illustration 1 g01282622The auxiliary start receptacle for the tractor is located on the right side front of the machine.
Illustration 2 g01152115The auxiliary start receptacle for the scraper is located on the left side rear of the machine.Some Caterpillar products may be equipped with auxiliary start receptacles as a standard part. All other machines can be equipped with a receptacle for parts service. Then, a permanent receptacle is always available for jump starting.Two cable assemblies are also available in order to jump start the stalled machine from another machine that is also equipped with this receptacle or with an auxiliary power pack. Your Caterpillar dealer can provide the correct cables for your application.
Move the transmission control of the stalled machine into the NEUTRAL position. Engage the parking brake. Lower the attachment to the ground. Refer to Operation and Maintenance Manual, "Equipment Lowering with Engine Stopped". Move all controls to the HOLD position.
Turn the engine start switch on the stalled machine to the OFF position. Turn off all accessories.
On the stalled machine, turn the battery disconnect switch to the ON position.
Move the machine that is being used as a power source so that the auxiliary starting cables can reach the stalled machine. Do not allow the machines to contact each other.
Stop the engine on the machine that is being used as a power source. If you are using an auxiliary power source, turn off the charging system.
Remove the dust covers on the auxiliary start receptacles.
On the stalled machine, connect the appropriate auxiliary starting cable to the auxiliary start receptacle.
Connect the other end of the auxiliary starting cable to the auxiliary start receptacle that is on the power source.
Start the engine on the machine that is being used as a power source. If you are using an auxiliary power source, energize the charging system on the auxiliary power source.
Wait for a minimum of two minutes while the batteries in the stalled machine partially charge.
Attempt to start the stalled engine. Refer to Operation and Maintenance Manual, "Engine Starting" in the Operation Section for the proper starting procedure for your machine.
Immediately after you start the stalled engine, disconnect the auxiliary starting cable from the power source.
Disconnect the other end of the auxiliary starting cable from the stalled machine.
Install the dust covers on the auxiliary start receptacles.
When the engine is running and the charging system is in operation, conclude the failure analysis on the starting charging system of the stalled machine, as required.
Severely discharged batteries will not fully recharge from the alternator alone after you jump start the machine. The batteries must be charged to the proper voltage with a battery charger. Many batteries that are considered to be unusable can still be recharged.