PIN 1868377 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2806 Alignment Tool 1 Note: The crankshaft rear seal and the housing for the crankshaft rear seal are manufactured as a one-piece assembly. The assembly of the crankshaft rear seal uses ten setscrews in order to fasten the assembly to the cylinder block.Note: The following procedure assumes that the crankshaft rear seal is a replacement assembly.Note: The crankshaft rear seal is lubricated. There is no need to lubricate the seal or the crankshaft flange before installation.Note: An installation sleeve (2) is supplied with the new housing assembly. The installation sleeve must be in place when housing assembly is installed on the crankshaft flange in order to prevent damage to the crankshaft rear seal during assembly.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the crankshaft flange (1) is clean, dry and free from rough metal edges. Ensure that the face of the cylinder block and the bridge in the crankcase are clean and dry.
Illustration 1 g01148393
Remove the packaging from the new assembly of the crankshaft rear seal (3). Ensure that the plastic sleeve (2) is squarely installed within the seal of the assembly of the crankshaft rear seal (3). The plastic sleeve (2) is included in order to protect the lip of the seal as the lip is pushed over the crankshaft flange (1).
Illustration 2 g01004958
Typical example
Place the assembly of the crankshaft rear seal (3) over the crankshaft flange (1) and engage the plastic sleeve (2) onto the crankshaft flange.
Ensure that the plastic sleeve (2) is engaged onto the crankshaft flange (1). Push the assembly of the crankshaft rear seal (3) evenly and push the assembly smoothly onto the crankshaft flange (1) until the assembly is against the cylinder block. During this process, the plastic sleeve (2) will be forced out of the assembly of the crankshaft rear seal (3). Discard the plastic sleeve (2).
Rotate the assembly of the crankshaft rear seal (3) in order to align the setscrew holes in the assembly with the setscrew holes in the rear face of the cylinder block.
Install the setscrews (5) in order to position housing assembly (3) to the cylinder block. Do Not tighten the bolts.
Place the Tooling (A) over housing assembly (2). This will center the housing assembly onto the crankshaft flange (3).
Illustration 3 g01148495
Tighten the setscrews (1) in numerical order to a torque of 22 N m (16 lb ft). Do not tighten the setscrews (X) at this time.
Remove the Tooling (A). Tighten the setscrews (X) to a torque of 22 N m (16 lb ft). End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".