PIN 1B0676 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7574 Link Bracket 2
B - Loctite 587 - Start By:
Remove the crankshaft rear seal.
Remove the electric starting motor.
Remove the air starting motor.
Remove the turbocharger.
Illustration 1 g03119296
Remove bolts (1) that fasten the engine oil pan to flywheel housing (2).
Illustration 2 g03119297
Install Tooling (A) and a suitable lifting device on flywheel housing (3). The weight of flywheel housing (3) is approximately 105 kg (230 lb).
Remove bolts (4). Remove flywheel housing (3) from the cylinder block.
Remove gasket (5) from the flywheel housing. Installation Procedure
Install flywheel housing (3) in the reverse order of removal.
Install gasket (5) on the dowel pins of the cylinder block. Apply Tooling (B) to the bottom of the gasket to fill the space at the cylinder block, the flywheel housing, and the engine oil pan.
Illustration 3 g00551652
Tightening Sequence
In a numerical sequence, tighten Bolt (1) through Bolt (9) to a torque of 100 20 N m (74 15 lb ft).
In a numerical sequence, tighten Bolt (10) through Bolt (24) to a torque of 40 10 N m (30 7 lb ft).
In a numerical sequence, tighten Bolt (1) through Bolt (9) to a torque of 135 20 N m (100 15 lb ft).
In a numerical sequence, tighten Bolt (10) through Bolt (24) to a torque of 55 10 N m (40 7 lb ft). End By:
Install the turbocharger, if necessary.
Install the electric starting motor.
Install the crankshaft rear seal.