PIN-TRACK 1Q4721 - Caterpillar

ECM Configuration
Table 1
Required Tools    
Part Number     Description     Quantity    
JEBD3003     Caterpillar Electronic Technician (ET)     1    
171-4401     Communications Adapter II     1    
207-6845     Adapter Cable As     1    
160-0141     Adapter Cable As     1    The Caterpillar Electronic Technician service tool (ET) is used to access the configuration screen. A message on the ET screen will give instructions that guide the user through the procedure. Refer to the Manual that is provided with the ET software for more information about ET.An ECM must be configured when the ECM has been replaced. The ECM needs to be configured before a calibration can be started.A check of the configuration screen could resolve a problem with the configuration of the machine. A problem with a component could be identified as one of the following items:
The component is not installed.
The component is installed but a change to the installation is needed in order to correct a problem.Follow these instructions to get to the configuration screen:
Illustration 1 g01177264
Typical Service Connector For the ET
Connect the communications adapter and the computer to the diagnostic service tool connector.
Start the Caterpillar Electronic Technician (ET).
Select "File". Go to "Select ECM". Choose the appropriate electronic control module.
Go to the "Service" Menu. Select "Configuration". Click "OK". Certain operations or characteristics can be changed for attachments or preferences.Configuration of the Power Train ECM
Illustration 2 g01177263
Power Train ECMThe power train ECM is located at the rear of the platform.Follow the instructions in Steps 1 through 4 above in order to configure the power train ECM.Configuration of the Engine ECM
Follow the instructions in Steps 1 through 4 above in order to configure the engine ECM.