AVSPARE.COM
parts catalog

PIN-TRACK 2061470 - Caterpillar


2061470 PIN-TRACK Caterpillar parts 1090, 1190, 320C FM, 320D, 320D FM, 320D FM RR, OEMS, TK711, TK721
Rating:
35
Alternative (cross code) number:
CA2061470
206-1470
2061470
Caterpillar 2061470 PIN-TRACK
Weight: 4 pounds 2 kg.

Buy PIN-TRACK 2061470 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, UNDERCARRIAGE,

Compatible equipment models: 2061470:

TRACK FELLER BUNCHER  1090   1190   TK711   TK721  
UNDERCARRIAGE  OEMS   Caterpillar
Number on catalog scheme: 7
  For full view, you need register

Information:


Illustration 1 g00561594
Schematic of the right solenoid (TCS)This diagnostic code is associated with the right solenoid (TCS). The FMI 03 means that the ECM has determined that the voltage of the solenoid circuit is above normal. The possible causes of the diagnostic code are listed:
The solenoid has failed.
The energize circuit of the solenoid is shorted to the +battery circuit.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0690 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The diagnostic code will be logged into memory and the traction control system (TCS) will be disabled.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the solenoid and the ECM.
At the machine harness connector for the ECM, measure the resistance from contact J2-64 (wire 775-BR) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-64 (775-BR) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE.
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 0690 FMI 03 is active.Expected Result:The CID 0690 FMI 03 is active.Results:
YES - The CID 0690 FMI 03 is active. The problem has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". Stop.
NO - The CID 0690 FMI 03 is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation. Stop.

Caterpillar parts catalog:

Caterpillar parts catalog
CIPI Undercarriages L5E00001-UP (MACHINE)
330 CIPI Excavator Track Systems L5E00001-UP (MACHINE)
CIPI Undercarriages L5E00001-UP (MACHINE)
TK721 Track Feller Buncher 10200001-UP (MACHINE) POWERED BY C-9 Engine
TK711 Track Feller Buncher 10100001-UP (MACHINE) POWERED BY C-9 Engine
1090 Track Feller Buncher BZJ00001-02109 (MACHINE)
1190 Track Feller Buncher BZK00001-02160 (MACHINE)
320C Forest Swing Machine BGB00001-UP (MACHINE) POWERED BY 3066 Engine
320C Forest Machines SAH00001-UP (MACHINE) POWERED BY 3066 Engine
320D RR FM Forest Swing Machine SRT00001-UP (MACHINE) POWERED BY 3066 Engine
320D Forest Machines BZF00001-UP (MACHINE) POWERED BY C6.4 Engine
320D Log Loader GKS00001-UP (MACHINE) POWERED BY C6.4 Engine
320D FM Forest Swing Machine BWW00001-UP (MACHINE) POWERED BY C6.4 Engine
320D2 FOREST MACHINE BW200001-UP (MACHINE) POWERED BY C7.1 Engine


Parts pin Caterpillar catalog:

1865662 PIN
320B, 320C, 320D, 320D FM, 320D L, 320D2, 320D2 L, 320E, 320E LN, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 325C, 325C FM, 325D, 325D FM, 325D L, 328D LCR, 329D, 329D L, 329D LN, 329E, 329E L, 329E L...
2502398 PIN AS
320C, 320C FM, 320C L
1883065 PIN-TRACK MASTER
320C, 322C, 322C FM, 323D LN, 323D SA, 325B L, 325C, 325C FM, 325C L, 325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 330C, 330C L, 330D, 330D L, 336D L, 336D LN, 336E, 345C, 345D, 349D L, OEMS
6Y8029 PIN-SPRING
1290T, 1390, 2491, 2590, 325C, 328D LCR, 330, 330 FM L, 330 L, 330B, 330B L, 330C, 330C FM, 330C L, 330C MH, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E H...
6Y2748 PIN-TRACK MASTER
1290T, 1390, 2491, 2590, 330, 330 FM L, 330 L, 330C FM, 330C L, 330D, 330D L, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L,...
1772502 PIN
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 330C, 330C FM, 330C L, 330C MH, 345B II, 345B II MH, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 552, 552 2, TK1051, TK711, TK721, TK...
6Y0850 PIN-TRACK MASTER
322C FM, 323E L, 324D FM, 324D FM LL, 325, 325 L, 325 LN, 325B L, 325C, 325C FM, 325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, OEMS
2641702 PIN AS
320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E LN, 321D LCR, 323D L, 323D LN, 323D SA, 323D2 L, 323E L
2343930 PIN
320D, 320D FM, 320D L, 320D2, 320D2 L, 320E, 320E LN, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 325D, 325D FM, 325D L, 328D LCR, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, 330D L
2343931 PIN AS
320D, 320D FM, 320D GC, 320D L, 320D LRR, 320D RR, 320D2, 320D2 L, 320E, 320E L, 320E LN, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D FM, 324D L, 324D LN, 324E, 324E L, 324E LN, 325D, 325D F...
2543052 PIN
320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321D LCR, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D L, 325D,...
2543053 PIN
320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321D LCR, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D L, 325D,...
2378169 PIN
320C, 325C, 330B L, 330C L, PIN GRAB
2378168 PIN
320C, 325C, 330B L, 330C L, PIN GRAB
2378167 PIN
320C, 325C, 330B L, 330C L, PIN GRAB
2378179 PIN-ROLL
320C, 325C, 330B L, 330C L, 330D L, 345C, 345C L, 345D L, PIN GRAB
1560161 PIN
320C, 330B L, HEX-WEDGE
1986319 PIN AS
M322C, M322D, M322D MH
1349007 PIN
320B FM LL, 320C FM, 320D
1373047 PIN AS
320B FM LL, 320C FM, 320D
1349037 PIN AS
320B FM LL, 320C FM, 320D
1372848 PIN AS
320B FM LL, 320C FM, 320D, 330C
1354177 PIN
320B FM LL, 320C, 320C FM, 320D FM
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.