PIN AS 2343942 - Caterpillar

The engine uses a strategy for the cold cylinder cutout to reduce white exhaust smoke after start-up and during extended idling in cold weather.During a cold start and/or extended periods at low idle. The engines Electronic Control Module (ECM) turns off one unit injector at a time in order to determine if each cylinder is firing by monitoring the change in the delivered fuel volume. If a cylinder is firing, the ECM turns on the injector. If a cylinder is not firing, the injector is turned off. This cold cylinder cutout provides the following benefits: reduction of white smoke, improved engine starting, reduction in the use of ether injection and reduction of warm-up time.Note: During operation of the cold cylinder cutout, the engine may seem to misfire. This action is normal. No corrective measures are necessary. The cold cylinder cutout is activated after all of the following conditions are met:
The cold cylinder cutout is programmed to ENABLE.
The engine speed is equal too high idle or below high idle.
The delivered fuel value is less than 275 mm (10.8 inch).
The jacket water coolant temperature is below 63 °C (145 °F) or the air inlet temperature is below 10° C (50° F).The cold cylinder cutout strategy is activated10 seconds after the engine starts and the engine reaches idle speed. Or 3 seconds after ether injection is completed.The cold cylinder cutout is deactivated if any of the following conditions are met:
The cold cylinder cutout is disabled with the Caterpillar Electronic Technician (Cat ET).
The jacket water coolant temperature rises above 70 °C (158 °F).
The cylinder cutout test is activated.
The ether injection is used.
The coolant temperature sensor has failed.If the delivered fuel volume is greater than 275 mm (10.8 inch), the cold cylinder cutout deactivates for 3 seconds.The cold cylinder cutout will deactivate for 3 seconds when the engine speed varies by more than 50 rpm as the cold cylinder cutout begins. A new engine speed is established when the cold cylinder cutout reactivates.The cold cylinder cutout deactivates for 30 seconds when the engine speed is at low idle for 10 seconds and the engine speed falls by more than 50 rpm below low idle.