AVSPARE.COM
parts catalog

PIN AS 2379355 - Caterpillar


2379355 PIN AS Caterpillar parts 416D, 416E, 416F, 420D, 420E, 420F, 430D, 430E, 430F
Rating:
20
Alternative (cross code) number:
CA2379355
237-9355
2379355
Caterpillar 2379355 PIN AS
Weight: 6 pounds 3 kg.

Buy PIN AS 2379355 Caterpillar genuine, new aftermarket tractor parts with delivery
BACKHOE LOADER,

Compatible equipment models: 2379355:

BACKHOE LOADER  416D   416E   416F   420D   420E   420F   430D   430E   430F   Caterpillar
Number on catalog scheme: 2
  For full view, you need register

Information:


Illustration 1 g00502027
Schematic of the Transmission Oil Pressure Sensor This diagnostic code is recorded when VIMS reads the current of the transmission oil pressure sensor as being above normal. The current of the signal wire is above normal and/or shorted to ground. The sensor sends a PWM signal to the VIMS module. The possible causes of this diagnostic code are listed here:
The sensor has failed.
The signal circuit in the machine harness is shorted to ground.
The VIMS interface module has failed. This is unlikely.
CHECK THE SENSOR.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the diagnostic code. Then disconnect the machine harness from the sensor.Expected Result: If the sensor is not the cause of the diagnostic code, the diagnostic code remains active. If the sensor has failed, the diagnostic code is NO longer active. Note: VIMS may wait up to approximately 30 seconds before updating the message area.Results:
OK - This diagnostic code remains active. The sensor is not causing the diagnostic code. The machine harness or the ECM may have failed. Proceed to 2.
NOT OK - This diagnostic code is NO longer active. The machine harness is correct and the ECM is operating properly. The sensor has failed. Replace the sensor. Refer to the Testing and Adjusting, "Pulse Width Modulated (PWM) Sensor -Test" section. STOP.
CHECK THE SIGNAL CIRCUIT FOR A SHORT TO GROUND.
The sensor remains disconnected from the machine harness.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the VIMS interface module.
At the machine harness connector for the VIMS interface module, measure the resistance between the signal contact and frame ground.Expected Result: The resistance is greater than 5000 ohms.Results:
OK - Resistance is greater than 5000 ohms. The harness circuit resistance is Correct. Proceed to 3
NOT OK - Resistance is less than 5000 ohms. The machine harness has failed. There is a short between frame ground and the signal circuit in the machine harness. Repair the machine harness or replace the machine harness. STOP.
CHECK IF THE DIAGNOSTIC CODE REMAINS.
Using established procedures, clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the diagnostic code.
Operate the machine.
Observe the status of the diagnostic code.Expected Result: The diagnostic code CID0127 FMI 06 is no longer active.Results:
YES - Diagnostic code is NOT active. The diagnostic code does not exist at this time. The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and then reconnected. Resume normal machine operation. STOP.
NO - Diagnostic code has not been corrected. It is unlikely that the ECM is faulty. Exit this CID/FMI procedure and perform this CID/FMI procedure again. If the cause of the fault is not found, then replace the VIMS interface module. See Testing And Adjusting, " Module - Replace". STOP.

Cat SIS web machinery list:

Caterpillar parts catalog
416D Backhoe Loader BFP00001-17198 (MACHINE) POWERED BY 3054 Engine
416D Backhoe Loader BFP05178-17198 (MACHINE) POWERED BY 3054 Engine
420D Backhoe Loader FDP07199-18399 (MACHINE) POWERED BY 3054 Engine
416D Backhoe Loader BGJ00523-01315 (MACHINE) POWERED BY 3054 Engine
420D Backhoe Loader BKC00502-UP (MACHINE) POWERED BY 3054 Engine
420D Backhoe Loader BMC00611-UP (MACHINE) POWERED BY 3054 Engine
416E Backhoe Loader Single Tilt Center Pivot SHA00001-UP (MACHINE) POWERED BY 3054C Engine
420E Backhoe Loader Single Tilt Center Pivot HLS00001-UP (MACHINE) POWERED BY 3054C Engine
420E Backhoe Loader Parallel Lift Center Pivot KMW00001-UP (MACHINE) POWERED BY 3054C Engine
416E Backhoe Loader Single Tilt Center Pivot CBD00001-UP (MACHINE) POWERED BY 3054C Engine
430E Backhoe Loader Center Pivot EAT00001-UP (MACHINE) POWERED BY 3054C Engine
430E Backhoe Loader Center Pivot DDT00001-UP (MACHINE) POWERED BY 3054C Engine
416D Backhoe Loader BFP12900-UP (MACHINE) POWERED BY 3054C Engine
420D Backhoe Loader FDP18400-UP (MACHINE) POWERED BY 3054C Engine
420D Backhoe Loader BLN10300-UP (MACHINE) POWERED BY 3054C Engine
430D Backhoe Loader BNK05900-UP (MACHINE) POWERED BY 3054C Engine
430D Backhoe Loader BML04800-UP (MACHINE) POWERED BY 3054C Engine
416D Backhoe Loader B2D00001-UP (MACHINE) POWERED BY 3054C Engine
416E Single Tilt Backhoe Loader BWC00001-UP (MACHINE) POWERED BY C4.4 Engine
420E Backhoe Loader Parallel Lift PHC00001-UP (MACHINE) POWERED BY C4.4 Engine
420E Backhoe Loader Single Tilt PRA00001-UP (MACHINE) POWERED BY C4.4 Engine
430E Backhoe Loader Parallel Lift SCD00001-UP (MACHINE) POWERED BY C4.4 Engine
430E Backhoe Loader Single Tilt RLN00001-UP (MACHINE) POWERED BY C4.4 Engine
416E Backhoe Loader Single Tilt LMS00001-UP (MACHINE) POWERED BY C4.4 Engine
420E Backhoe Loader Parallel Lift DAN00001-UP (MACHINE) POWERED BY C4.4 Engine
420E Backhoe Loader Single Tilt DJL00001-UP (MACHINE) POWERED BY C4.4 Engine
430E Backhoe Loader Parallel Lift MXB00001-UP (MACHINE) POWERED BY C4.4 Engine
430E Backhoe Loader Single Tilt SWC00001-UP (MACHINE) POWERED BY C4.4 Engine
420F Backhoe Loader LKH00001-UP (MACHINE) POWERED BY C4.4 Engine
420F Backhoe Loader LTG00001-02342 (MACHINE) POWERED BY C4.4 Engine
430F Backhoe Loader LNH00001-UP (MACHINE) POWERED BY C4.4 Engine
430F Backhoe Loader LDY00001-00281 (MACHINE) POWERED BY C4.4 Engine
416F Backhoe Loader LWT00001-UP (MACHINE) POWERED BY C4.4, 3054C Engine
416F Backhoe Loader KSF00001-UP (MACHINE) POWERED BY C4.4 Engine
420F Backhoe Loader JWJ00001-UP (MACHINE) POWERED BY C4.4 Engine
420F Backhoe Loader SKR00001-UP (MACHINE) POWERED BY C4.4 Engine
430F Backhoe Loaders RGS00001-UP (MACHINE) POWERED BY C4.4 Engine
430F Backhoe Loaders RDF00001-UP (MACHINE) POWERED BY C4.4 Engine
416F2 Center Pivot Backhoe Loader LYA00001-UP (MACHINE) POWERED BY C4.4 Engine
420F2 Center Pivot Backhoe Loader LYB00001-UP (MACHINE) POWERED BY C4.4 Engine
420F2 IT Center Pivot Backhoe Loader LYC00001-UP (MACHINE) POWERED BY C4.4 Engine
430F2 Center Pivot Backhoe Loader LYD00001-UP (MACHINE) POWERED BY C4.4 Engine
430F2 IT Center Pivot Backhoe Loader LYE00001-UP (MACHINE) POWERED BY C4.4 Engine
415F2 Center Pivot Backhoe Loader HWA00001-UP (MACHINE) POWERED BY C3.4 Engine
416F2 Center Pivot Backhoe Loader HWB00001-UP (MACHINE) POWERED BY C4.4 Engine
420F2 Center Pivot Backhoe Loader HWC00001-UP (MACHINE) POWERED BY C4.4 Engine
420F2 IT Center Pivot Backhoe Loader HWD00001-UP (MACHINE) POWERED BY C4.4 Engine
430F2 Center Pivot Backhoe Loader HWE00001-UP (MACHINE) POWERED BY C4.4 Engine
430F2 IT Center Pivot Backhoe Loader HWG00001-UP (MACHINE) POWERED BY C4.4 Engine
416F2 Center Pivot Backhoe Loader LBF00001-UP (MACHINE) POWERED BY 3054C, C4.4 Engine
420F2 Center Pivot Backhoe Loader LBS00001-UP (MACHINE) POWERED BY 3054C, C4.4 Engine
420F2 ADL (Air Deployable Loader) NSB00001-UP (MACHINE) POWERED BY 3054C Engine


Parts pin Caterpillar catalog:

2136714 PIN
416E, 416F, 422E, 428E
2201019 PIN
416E, 416F, 420E, 420F, 422E, 428E, 430E, 430F, 432E, 434E, 442E, 444E
2616703 PIN
416E, 420E, 430E
2146143 PIN
416E, 416F, 420E, 420F, 422E, 428E, 430E, 430F, 432E, 434E, 442E, 444E, 450E, 450F
2170055 PIN
416E, 416F, 420E, 420F, 422E, 428E, 430E, 430F, 432E, 434E, 442E, 444E, 450E, 450F
2201018 PIN
416E, 416F, 420E, 420F, 422E, 428E, 430E, 430F, 432E, 434E, 442E, 444E
2136696 PIN
416E, 416F, 420E, 420F, 422E, 428E, 430E, 430F, 432E, 434E, 442E, 444E
2136697 PIN
416E, 416F, 420E, 420F, 422E, 428E, 430E, 430F, 432E, 434E, 442E, 444E
2136693 PIN
420E, 420F, 432E, 434E
2136695 PIN
420E, 420F, 432E, 434E
2159448 PIN AS
420E, 420F, 432E, 434E
2H3768 PIN-COTTER
120G, 12F, 12G, 130G, 140G, 14E, 216B3, 226B3, 236B3, 236D, 242B3, 242D, 246C, 246D, 247B3, 252B3, 256C, 257B3, 257D, 259B3, 259D, 262C, 262C2, 262D, 272C, 272D, 272D XHP, 277C, 277C2, 277D, 279C, 279...
2264342 PIN AS
TH560B, TH580B
2096855 PIN
416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E, 444E
2096850 PIN AS
416E, 416F, 420E, 420F, 422E, 428E, 432E, 434E
3005440 PIN
416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E, 444E
2061766 PIN
414E, 416E, 416F, 420E, 420F, 422E, 422F, 428E, 428F, 430E, 430F, 432E, 432F, 434E, 434F, 442E, 444E, 444F, 450E, 450F
2K5986 PIN-SPRING
120H, 12H, 135H, 140H, 143H, 14G, 14H, 14H NA, 160H, 163H, 16G, 16H, 16H NA, 414E, 416E, 416F, 420E, 420F, 422E, 422F, 428E, 428F, 430E, 430F, 432E, 432F, 434E, 434F, 442E, 444E, 444F, 450E, 450F, 515...
2119286 PIN AS
414E, 416E, 420E, 422E, 428E, 430E, 432E, 442E
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.