PIN-PIVOT 2519832 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".Note: Cleanliness is an important factor. Before the removal procedure, thoroughly clean the exterior of the component. Cleaning the exterior of the component will prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes to prevent fluid loss and to keep contaminants from entering the system.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the capacity of the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Illustration 1 g02567456
Move cover (1) aside.
Remove four bolts (2) .
Illustration 2 g02567457
Remove clamp (3) below cover (1) .
Illustration 3 g02567476
Using two people, remove tube assembly (4) . The weight of tube assembly (4) is approximately 27 kg (60 lb).
Illustration 4 g02567477
Remove cover (5) .
Illustration 5 g02592358
Disconnect elbow (6) from the turbocharger.
Illustration 6 g02592359
Loosen the clamps and disconnect hose (7) from the elbow.
Illustration 7 g02567478
Loosen clamp (8) .
Illustration 8 g02567479
Remove clamp assembly (9) .