PIN-PISTON 2638955 - Caterpillar

Illustration 1 g01008783
The Remote Status Panel allows the user to monitor various functions through use of eight status lights.The Alarm Settings and The Status Settings
Note: These settings have been predefined.
Table 1
Alarm Indicator or Status Indicator    Color of LED    
"Bypass Unavailable"     Amber    
"UPS Notice"     Amber    
"On-bypass"     Amber    
"Discharging"     Amber    
"Overload"     Red    
"Low DC Voltage (to panel)"     Red    
"UPS Alarm"     Red    
"Off-line"     Red    Connecting to the UPS
When servicing or repairing electric power generation equipment:Make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE. Remove all fuses.
Wear a well grounded wrist strap and perform work in a static free environment. Electrostatic discharge can damage the monitor and components.
Note: The system must be at a dead stop. There should be no power that is available.The system is designed for flush mounting or surface mounting in a panel box. The system uses 18 AWG or larger wire. The wire will consist of 3 conductors. The wire consists of a data conductor, a ground conductor, and a power conductor. There are 14 screw connections on the back of the status panel that are labelled. Refer to Table 2.
Table 2
Connections (Remote Status Panel)    Connections (System Input/Output Daughter board) (J5)    
Terminal 1 "+24 VDC"     Connection 1 (25)    
Terminal 2 "Serial data in"     Connection 5 (27)    
Terminal 3 "Spare"        
Terminal 4 "Spare"        
Terminal 5 "Spare"        
Terminal 6 "Jumper to 7"        
Terminal 7 "Ground"     Connection 3 (26)    
Terminal 8 "Spare"        
Terminal 9 "Jumper to 6"        
Terminal 10 "Spare"        
Terminal 11 "Spare"        
Terminal 12 "Lamp test (1)"        
Terminal 13 "Horn silence (1)"        
Terminal 14 "Horn output (1)"        The following steps will aid in the process of connecting a Remote Status Panel.
Verify the location and the condition of the wiring connections at the back of Remote Status Panel.
Illustration 2 g01157433
Illustration 3 g01011380
Connector "J5"
Route the wires from the remote status panel to the locations on the output connector "J5" (21) on the System Input/Output Daughter board.Refer to Illustration 3 for the locations on the output connector "J5" for the System Input/Output Daughter board.The installation of the Remote Status Panel is complete.
Table 3
"J5" Wire Connections    
Connection 1 (25)     "+24 VDC"    
Connection 3 (26)     "GND" (Ground)    
Connection 5 (27)     "Data"    
Return your system to operational status.
Once you see the telemetry data on the User Interface Panel, establish your connection by using UPS View.
Continue to "Enabling the Option with UPS View".Enabling the Option with UPS View
Note: A special password is required in order to enable the option.
Contact Service Support for a Password.
Illustration 4 g01011838
Click on the "Enter Password" option.
Illustration 5 g00787622
Enter your authorized username and a password.The top menu option