PIN AS 2641703 - Caterpillar

Removal Procedure
Start By:
Remove the counterweight. Refer to Disassembly and Assembly, "Counterweight - Remove".
Illustration 1 g00711956
Remove two bolts (3) and the washers from the hinge.
Remove three bolts (1) and the washers in order to remove access panel (2) .
Illustration 2 g00712442
Remove three bolts (5) and the washers in order to remove access panel (4) .
Open the engine hood.
Illustration 3 g00711961
Remove two nuts (6) that secure governor linkage (7) to the fuel injection pump.
Illustration 4 g00711972
Loose nut (8) and (9) that secures governor linkage (7) to the engine.
Illustration 5 g00711979
Remove two bolts (10) and the washers in order to remove two clamps (11) that secure the governor linkage to the chassis.Note: Some models may only have one clamp (11) .
Illustration 6 g00711980
Disconnect electrical connector (13) .
Remove two bolts (14) and the two washers. Remove governor control motor (12) .Installation Procedure
Illustration 7 g00711980
Position governor control motor (12) on the mounting bracket. Install the two washers and two bolts (14) .
Connect electrical connector (13) .
Illustration 8 g00711979
Install two clamps (11) that secure the governor linkage to the chassis.Note: Some models may only have one clamp (11) .
Install two bolts (10) and the washers that hold clamps (11) in position.
Illustration 9 g00711972
Install governor linkage (7) . Fasten governor linkage (7) with nut (8) and nut (9) .
Illustration 10 g00711961
Install governor linkage (7) to the fuel injection pump. Fasten governor linkage (7) with washers and two nuts (6) .
Illustration 11 g00712442
Install access panel (4) . Install the washers and three bolts (5) .
Illustration 12 g00711956
Install access panel (2) . Install the washers and three bolts (1) .
Install the washers and two bolts (3) to the hinge.
Close the engine hood.
Check the governor actuator.ReferenceRefer to Systems Operation/Testing and Adjusting, "Governor Actuator - Calibrate" for further information.End By: Install the counterweight. Refer to Disassembly and Assembly, "Counterweight - Install".