PIN AS 2969540 - Caterpillar

all maintenance including the following procedures: all adjustments, the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.When Required
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Sample (Level 1) - Obtain
Coolant Temperature Regulator - Replace
Engine Oil and Filter - Change
Fuel System - Prime
Heat Exchanger - Inspect
Maintenance Recommendations
Sea Water Strainer - Clean/Inspect
Zinc Rods - Inspect/Replace
Daily
Air Tank Moisture and Sediment - Drain
Battery - Replace
Control Panel - Inspect/Test
Coolant Level - Check
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Engine Oil Filter Differential Pressure - Check
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Walk-Around Inspection
Initial 250 Service Hours
Fuel Injector - Inspect/Adjust
Every 250 Service Hours
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Hoses and Clamps - Inspect/Replace
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Fuel Filter Differential Pressure - Check
Every 1000 Service Hours
Engine - Clean
Engine Crankcase Breather - Clean
Engine Protective Devices - Check
Fuel System Primary Filter/Water Separator - Clean/Replace
Fuel System Secondary Filter - Replace
Every 2000 Service Hours
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine Mounts - Inspect
Fumes Disposal Filter Element - Replace
Turbocharger - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Every 4000 Service Hours
Auxiliary Water Pump - Inspect
Engine Valve Lash - Check
Fuel Filter Differential Pressure - Check
Fuel Injector - Inspect/Adjust
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 6000 Service Hours or 6 Years
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Engine Speed/Timing Sensor - Clean/Inspect
Prelube Pump - Inspect
Starting Motor - Inspect
Water Pump - Inspect
Every 8000 Service Hours or 3 Years
Camshaft Roller Followers - Inspect
Overhaul
Aftercooler Core - Inspect/Clean/Test
Overhaul (Major)
Overhaul (Top End)
Overhaul Considerations