PIN 2K5599 - Caterpillar

Personal injury can result from flame cutting or welding on painted areas.The effect of gasses from burned paint is a hazard to the person doing the cutting or welding.Do not flame cut or weld on painted areas.
Personal injury or death can result from fumes, gases and ultraviolet rays from the weld arc.Welding can cause fumes, burn skin and produce ultraviolet rays.Keep your head out of the fumes. Use ventilation, exhaust at the arc, or both, to keep fumes and gases from your breathing area. Wear eye, ear and body protection before working.Protect yourself and others; read and understand this warning. Fumes and gases can be dangerous to your health. Ultraviolet rays from the weld arc can injure eyes and burn skin. Electric shock can cause death.Read and understand the manufacturer's instructions and your employer's safety practices. Do not touch live electrical parts.See "American National Standard Z49.1, Safety in Welding and Cutting" published by the American Welding Society.American Welding Society
2501 N.W. 7th Street
Miami, Florida 33125
See "OSHA Safety and Health Standards, 29 CFR 1910", available from U.S. Department of Labor.U.S. Department of Labor
Washington, D.C. 20210
Remove the existing 240-1557 Bracket As without damaging the blade. Discard the bracket after removal. A new 240-1557 Bracket As is needed to replace the discarded bracket. Weld the new parts in the position that are shown in the following illustrations.
Illustration 1 g01206413
D5N AKD1-UP (1) 274-9275 Plate (2) 240-1557 Bracket As Note: A new 274-9275 Plate (1) is also required for the assembly on the D5N AKD1-UP blade.Position the new 274-9275 Plate (1) on the blade. Weld the plate to the blade with 6 mm (0.2362 inch) fillet welds on all contacting surfaces. Position the new 240-1557 Bracket As (2) on the new 274-9275 Plate (1). Weld the bracket to the plate with 6 mm (0.2362 inch) fillet welds on all contacting surfaces.
Illustration 2 g01206768
D5N AGG1-UP (2) 240-1557 Bracket As
Illustration 3 g01206775
D6N ALY1-UP (2) 240-1557 Bracket As
Illustration 4 g01206777
D6N AKM1-UP (2) 240-1557 Bracket As Note: Refer to the following Illustrations for the location of bracket (2) : 2, 3 and 4. Weld the bracket with 6 mm (0.2362 inch) fillet welds on all contacting surfaces.