AVSPARE.COM
parts catalog

PIN AS 3236583 - Caterpillar



3236583 PIN AS Caterpillar parts PIN
Rating:
36
Alternative (cross code) number:
CA3236583
323-6583
3236583
Caterpillar 3236583 PIN AS

Buy PIN AS 3236583 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Start By:
Release the system pressure.
Connect the steering frame lock.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all hoses and on all hose assemblies for installation purposes. Plug all hose assemblies. This helps to prevent fluid loss and to keep contaminants from entering the system.
Illustration 1 g01333601
Remove bolts (2) and cover (1) from the tilt cylinder.
Illustration 2 g01333605Note: The quantity and location of the shims should be noted down for assembly purposes.
Disconnect hose assemblies (3).
Attach a suitable lifting device to tilt cylinder (4). The weight of tilt cylinder (4) is approximately 45 kg (99 lb).
Remove nuts (5), the bolts, the caps, and the shims.
Remove bolts (8) and retainer (7). Remove pin (6).
Use the suitable lifting device to remove tilt cylinder (4) from the machine.Installation Procedure
Install tilt cylinder (4) in the reverse order of removal.


Parts pin Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.