PIN AS 3281224 - Caterpillar

Illustration 1 g01399863
Left side view of engine
Note: The rear face of the cylinder block and the front face of the rear housing (1) must be free of oil, fuel, water, dirt, assembly compounds and any other contaminants during assembly. The gasket for the rear housing must also be free of contaminants during assembly. (B) Dowel extension from the rear housing at two places ... 19.0 0.5 mm (0.75 0.02 inch)
Illustration 2 g01399864
View A-A
(3) Cylinder block (2) Apply a continuous bead of 230-6262 Sealant immediately prior to assembling the rear housing. After assembly of the rear housing, remove any excess sealant from the flange with a straight edge. (4) Apply 230-6262 Sealant to the T-shaped joints immediately prior to the installation of the gasket for the pan. The application of the sealant should cover the entire width of the T-shaped joints, as shown.
Illustration 3 g01399869
Rear view
Use the following procedure to tighten the bolts for the rear housing:
Start with bolt (5) and continue to tighten all of the remaining bolts in the numerical sequence that is shown to a torque of 55 10 N m (41 7 lb ft).
Bolt (5) and bolt (6) are 3/8-16 X 1 3/4 inches.
Bolts (7) through bolts (14) are 3/8-16 X 2 1/4 inches.